ClearOne comm AP10 Set connector pinout, Line connector pinout, Appendix C Serial Commands

Page 25

	Appendices ~ Appendix B: Pinouts				21
	Appendices ~ Appendix B: Pinouts				21
	Set connector pinout
	Set connector pinout
	Pin	Description	Pin	Description

1		To pin 6 of SET RJ-11C	4	Tip
2		To pin 5 of SET	5	To pin 2 of LINE
3		Ring	6	To pin 1 of LINE RJ-11C

	Line connector pinout
	Pin	Description	Pin	Description

1		To pin 6 of LINE RJ-11C	4	Ring
2		To pin 5 of LINE	5	To pin 2 of SET
3		Tip	6	To pin 1 of SET RJ-11C

Appendix C: Serial Commands

The AP10 accepts serial commands via the AP800’s serial port; the commands are passed to the unit through the

G-Link network. The commands in this manual pertain only to the AP10. RS-232 serial port protocol is 9,600 (default), 19,200, or 38,400 baud; 8 bits, 1 stop bit, no parity.

Conventions

The following typographic conventions are used in this document to describe the different serial commands. Use the Command structure section and the examples as a guide when creating your serial commands.

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Image 25

Contents AP10 Telephone Interface Technical Services Group ~ 1-800-283-5936 USA ~ Iii Table of ContentsOperation AppendicesIntroduction FeaturesSales and Customer Service Professional Services GroupTechnical Support ClearOne Communications EuMEA GmbHControls and Connections UnpackingFront view Introduction ~ Controls and ConnectionsRear view AP10 rear-panel connectorsPower requirements Before You InstallEquipment placement Telephone line requirementsTechnical Services Group ~ 1-800-283-5936 USA ~ Connect the unit Hardware SetupPhoenix connector Installation ~ Hardware SetupCreating a G-Link network Device ID DIP switch settings Connecting powerBinary DIP Switch Address Position Assigning device ID numbersTechnical Services Group ~ 1-800-283-5936 USA ~ Noise burst/auto-adapt DIP Switch SettingsReceive boost Auto-answer Receive AGCAuto-disconnect Call progression/loopCalibration Receive reductionNoise burst adapt RingingReceive level adjustment Transmit level adjustmentAuto-adapt To answer a call Using the AP10To make and disconnect a call Found Using the Telco InterfaceOther telco options To muteControllers Custom control through DB-25 portTechnical Services Group ~ 1-800-283-5936 USA ~ Appendices Appendix a SpecificationsAppendix B Pinouts Remote connector pinoutAppendices ~ Appendix B Pinouts Pin DescriptionLine connector pinout Set connector pinoutAppendix C Serial Commands ConventionsExample Command structureConvention Description Appendices ~ Appendix C Serial Commands AP10 Serial CommandsCommand Function Command form Device AACommand form Device Hookd Command form Device HookExample Command form Device Mute CH Explanation Command form Device LVL CHCommand form Device TE Command form Device NullCommand form Device Terl Return values Return valuesCommand form Device UID Command form Device TerleCommand form Device VER This Warranty is Void if Appendix D WarrantyAppendices ~ Appendix D Warranty FCC Part 15 Compliance Appendix E ComplianceFCC Part 68 Compliance Usoc Jacks This device uses RJ-11C and RJ21X terminal jacksIC Compliance Safety InformationAppendices ~ Appendix E Compliance Appendix F Block Diagram Glossary Acoustic Echo Cancellation AECGlossary Index Index