ClearOne comm AP10 Before You Install, Power requirements, Telephone line requirements

Page 9

Introduction ~ Before You Install

Before You Install

Power requirements

The AP10 automatically accommodates voltage requirements of 100–240VAC, 50/60Hz, 15W.

Telephone line requirements

The AP10 model operates on a standard analog telephone line and connects to the telephone system with a standard RJ-11C modular jack. If you do not have an RJ-11C jack where you want to install your AP10, call your telephone company for installation.

Equipment placement

The AP10 models are designed for installation in a standard 19-inch equipment rack. You can also purchase side panels for desktop placement.

Environmental requirements

The AP10 can be safely operated in a room with varying temperatures between 32°F (0°C) and 100°F (38°C).

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Image 9

Contents AP10 Telephone Interface Technical Services Group ~ 1-800-283-5936 USA ~ Iii Table of ContentsOperation AppendicesIntroduction FeaturesSales and Customer Service Professional Services GroupTechnical Support ClearOne Communications EuMEA GmbHControls and Connections UnpackingFront view Introduction ~ Controls and ConnectionsRear view AP10 rear-panel connectorsPower requirements Before You InstallEquipment placement Telephone line requirementsTechnical Services Group ~ 1-800-283-5936 USA ~ Connect the unit Hardware SetupInstallation ~ Hardware Setup Phoenix connectorCreating a G-Link network Device ID DIP switch settings Connecting powerBinary DIP Switch Address Position Assigning device ID numbersTechnical Services Group ~ 1-800-283-5936 USA ~ DIP Switch Settings Noise burst/auto-adaptReceive boost Auto-answer Receive AGCAuto-disconnect Call progression/loopCalibration Receive reductionNoise burst adapt RingingTransmit level adjustment Receive level adjustmentAuto-adapt Using the AP10 To answer a callTo make and disconnect a call Found Using the Telco InterfaceOther telco options To muteControllers Custom control through DB-25 portTechnical Services Group ~ 1-800-283-5936 USA ~ Appendices Appendix a SpecificationsAppendix B Pinouts Remote connector pinoutAppendices ~ Appendix B Pinouts Pin DescriptionLine connector pinout Set connector pinoutAppendix C Serial Commands ConventionsCommand structure ExampleConvention Description Appendices ~ Appendix C Serial Commands AP10 Serial CommandsCommand Function Command form Device AACommand form Device Hook Command form Device HookdExample Command form Device Mute CH Explanation Command form Device LVL CHCommand form Device TE Command form Device NullCommand form Device Terl Return values Return valuesCommand form Device Terle Command form Device UIDCommand form Device VER This Warranty is Void if Appendix D WarrantyAppendices ~ Appendix D Warranty FCC Part 15 Compliance Appendix E ComplianceFCC Part 68 Compliance Usoc Jacks This device uses RJ-11C and RJ21X terminal jacksSafety Information IC ComplianceAppendices ~ Appendix E Compliance Appendix F Block Diagram Glossary Acoustic Echo Cancellation AECGlossary Index Index