ClearOne comm AP10 operation manual Appendices ~ Appendix D Warranty

Page 33

Appendices ~ Appendix D: Warranty

29

Manufacturer shall not be liable for punitive, consequential, or incidental damages, expenses, or loss of revenue or property, inconvenience, or interruption in operation experienced by the end user due to a malfunction in the purchased product. No warranty service performed on any product shall extend the applicable warranty period.

In case of unsatisfactory operation, the end-user shall promptly notify the

Manufacturer at the address set forth below in writing, giving full particulars as to the defects or unsatisfactory operation. Upon receipt of such notice, the Manufacturer will give instructions respecting the shipment of the product, or such other matters as it elects to honor this warranty as above provided. This warranty does not cover damage to the product during shipping and the Manufacturer assumes no responsibility for such damage. All shipping costs shall be paid by the customer.

This warranty extends only to the original end user and is not assignable or transferable. This Warranty is governed by the laws of the State of Utah, without regard to the conflicts of interests provisions thereof.

ClearOne Communications, Inc.

1825 Research Way

Salt Lake City, Utah 84119

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Image 33

Contents AP10 Telephone Interface Technical Services Group ~ 1-800-283-5936 USA ~ Iii Table of ContentsOperation AppendicesIntroduction FeaturesSales and Customer Service Professional Services GroupTechnical Support ClearOne Communications EuMEA GmbHControls and Connections UnpackingFront view Introduction ~ Controls and ConnectionsRear view AP10 rear-panel connectorsPower requirements Before You InstallEquipment placement Telephone line requirementsTechnical Services Group ~ 1-800-283-5936 USA ~ Connect the unit Hardware SetupInstallation ~ Hardware Setup Phoenix connectorCreating a G-Link network Device ID DIP switch settings Connecting powerBinary DIP Switch Address Position Assigning device ID numbersTechnical Services Group ~ 1-800-283-5936 USA ~ DIP Switch Settings Noise burst/auto-adaptReceive boost Auto-answer Receive AGCAuto-disconnect Call progression/loopCalibration Receive reductionNoise burst adapt RingingTransmit level adjustment Receive level adjustmentAuto-adapt Using the AP10 To answer a callTo make and disconnect a call Found Using the Telco InterfaceOther telco options To muteControllers Custom control through DB-25 portTechnical Services Group ~ 1-800-283-5936 USA ~ Appendices Appendix a SpecificationsAppendix B Pinouts Remote connector pinoutAppendices ~ Appendix B Pinouts Pin DescriptionLine connector pinout Set connector pinoutAppendix C Serial Commands ConventionsCommand structure ExampleConvention Description Appendices ~ Appendix C Serial Commands AP10 Serial CommandsCommand Function Command form Device AACommand form Device Hook Command form Device HookdExample Command form Device Mute CH Explanation Command form Device LVL CH Command form Device TE Command form Device Null Command form Device Terl Return values Return valuesCommand form Device Terle Command form Device UIDCommand form Device VER This Warranty is Void if Appendix D WarrantyAppendices ~ Appendix D Warranty FCC Part 15 Compliance Appendix E ComplianceFCC Part 68 Compliance Usoc Jacks This device uses RJ-11C and RJ21X terminal jacksSafety Information IC ComplianceAppendices ~ Appendix E Compliance Appendix F Block Diagram Glossary Acoustic Echo Cancellation AECGlossary Index Index