CH Tech EM405D user manual Current Port Profile TCP Sockets

Page 42

Table C-1. Wireless Ethernet Configuration Default Settings. (continued)

Enable Line Printer Daemon (LPD)	True
- Port	515
Enable RealPort	True
- Port	771
Enable Remote Login (rlogin)	True
- Port	513
Enable Remote Shell (rsh)	True
- Port	514
Enable SNMP	True
- Port	161
Enable Telnet	True
- Port	23

Advanced Network Settings
Enable AutoIP address assignment	True
RTS Threshold	2347
Fragmentation Threshold	2346

Serial Port
Port Profile Settings
Current Port Profile	TCP Sockets

TCP Server Settings
Enable Telnet access using TCP Port	False
- Port	N/A
Enable Raw TCP access using TCP Port	True
- Port**	10001
Enable Secure Socket access using TCP Port	False
- Port	N/A

TCP Client Settings
Automatically establish TCP connections	False

Basic Serial Settings
Description	blank
Baud Rate	230400
Data Bits	8
Parity	None
Stop Bits	1
Flow Control	None

**The EM405D will operate with any port number; however, many software applications expect the port to be set to the default as shown in this table. Changing the port number will not render the EM405D inoperable but may render these software applications inoperable.

C-2

Image 42

Contents H E R N E T Copyright Copyright 2004 by C&H Technologies, IncDocument Revision Notice Introduction Functional Description Table of Contents General DescriptionInstallation Operating InstructionsEM405D Ethernet M-Module Carrier List of TablesFeatures and Specifications Key FeaturesPurpose of Equipment Specifications Maximum RatingsEnvironmental ElectricalMechanical Bus ComplianceApplicable Documents Installation Unpacking and Inspection Handling PrecautionsInstallation of M-MODULES MA Configuration Diagram Functional Description General Ethernet InterfacePower Conversion Module InterfaceRear Panel Front Panel Front PanelPage Configuring the Ethernet Interface Operating Instructions GeneralIP Address Default subnet mask is Gateway Default gateway address is Port NumbersRecommendation Default setting is Auto-Scan Telnet x.x.x.x Performing the Configuration Wireless Ethernet Wi-Fi Page Communicating with the Carrier and M-MODULES Table I. Command SummaryError Handling Table II. Status Code SCPage Write Data command Read Data commandBlock Access Starting address + block size * word sizeNumber of bytes = number of blocks * block size * word size 0x50 md as ws ad ai nh nl bs 5 EM405D Configuration/Status Registers Table III. Register SummaryHardware Version Reset Error & Manufacturer IdentificationDevice Identification Firmware VersionReset & Trigger Control Fan Control & Temperature StatusControlling the Triggers Following values would be invalidFAN and Temperature Control Page Figure A-1 -Pin Dsub Connector Page Appendix B Wired Ethernet Default Settings Table B-1. Ethernet Interface Default SettingsOn Passive Connection True CPU Performance High Page Table C-1. Wireless Ethernet Configuration Default Settings Wireless LAN SettingsCurrent Port Profile TCP Sockets Gpio Page T E S Page Readers Comment Form CommentsInstructions