CH Tech EM405D user manual Module Interface, Power Conversion, Rear Panel

Page 14

3.1.3 M-module Interface

The M-module interface provides the mechanism for the microcontroller to access the M- modules. It is implemented using programmable logic that emulates a bridge between the microcontroller and the M-module bus. The logic also provides trigger configuration and control.

3.1.4 Power Conversion

The +12V input power is converted to the +3.3V power required by the carrier and the +5V, +12V, and -12V power required by the M-modules. The input power can be supplied through the 2.5mm power jack connector or through pins on the 9-pin DSUB connector.

3.2 REAR PANEL

The rear panel of the EM405D contains a +12V power input connection, an Ethernet connection or wireless antenna and a 9-pin DSUB connector that provides connection to M-module trigger lines and an alternate power input connection. Also found on the rear panel are the fan and an On/Off switch. Figure 5 shows the rear panel of the module. Refer to Appendix A for pin-out details of the 9-pin DSUB connector.

ETHERNET		POWER
ETHERNET
10/100 BASE-T	J1	ON
		OFF

+12VDC

IN

Figure 5. Rear Panel

8

Image 14

Contents H E R N E T Copyright Copyright 2004 by C&H Technologies, IncDocument Revision Notice Introduction Functional Description Table of Contents General DescriptionInstallation Operating InstructionsEM405D Ethernet M-Module Carrier List of TablesPurpose of Equipment Features and SpecificationsKey Features Specifications Maximum RatingsEnvironmental ElectricalMechanical Bus ComplianceApplicable Documents Installation of M-MODULES Installation Unpacking and InspectionHandling Precautions MA Configuration Diagram Functional Description General Ethernet InterfaceRear Panel Power ConversionModule Interface Front Panel Front PanelPage IP Address Configuring the Ethernet InterfaceOperating Instructions General Recommendation Default subnet mask is GatewayDefault gateway address is Port Numbers Default setting is Auto-Scan Telnet x.x.x.x Performing the Configuration Wireless Ethernet Wi-Fi Page Communicating with the Carrier and M-MODULES Table I. Command SummaryError Handling Table II. Status Code SCPage Write Data command Read Data commandBlock Access Starting address + block size * word sizeNumber of bytes = number of blocks * block size * word size 0x50 md as ws ad ai nh nl bs 5 EM405D Configuration/Status Registers Table III. Register SummaryHardware Version Reset Error & Manufacturer IdentificationDevice Identification Firmware VersionReset & Trigger Control Fan Control & Temperature StatusControlling the Triggers Following values would be invalidFAN and Temperature Control Page Figure A-1 -Pin Dsub Connector Page Appendix B Wired Ethernet Default Settings Table B-1. Ethernet Interface Default SettingsOn Passive Connection True CPU Performance High Page Table C-1. Wireless Ethernet Configuration Default Settings Wireless LAN SettingsCurrent Port Profile TCP Sockets Gpio Page T E S Page Readers Comment Form CommentsInstructions