Delta Electronics RTU-EN01 operation manual Application Examples DCISoft, Smart PLC IF-THEN

Modbus TCP Remote I/O Communication Module RTU-EN01

7 Application Examples – DCISoft

7.15 Smart PLC: IF-THEN

Application Setting up IF-THEN in Smart PLC functions by using DCISoft.
Steps	1. When RX#0 and RX#1 are ON, set RY0 to output.
	2. When RX#2 turns from OFF to ON, set RY1 to reversing its direction.

1. See the connection method (as below) and 6.1 for how to set up communication.

PC

	Ethernet
10N EU- TR	TS8 0-P VD	DVP-16SP
	COM2
RTU-EN01		DI/DO

DA	CT	TP	DA
40	40	40	02
P-V D	PV- D	-PV D	DVP-

AI/AO

2.Open the setup page and switch to “Smart PLC” page.

3.Select “RX 0 On” and “RX 1 On” in the IF column and select “AND” for the relation between conditions. Next, select “RY 0 Set” in the THEN column and press “Add” to add the settings into the table below.

4.Select “RX 2 Rising” in the IF column and “RY 1 Toggle” in the THEN column. Press “Add” to add the settings into the table below. Press “Apply” to store these settings into RTU-EN01.

42 DVP-PLC Operation Manual