Part names
Part names
Projector
(1)Lamp cover (52) The lamp unit is inside.
(2)Focus ring (16)
(3)Zoom ring (16)
(4)Control panel (5)
(5)Speaker (32)
(6)Elevator knobs (x 2) (16)
(7)Elevator feet (x 2) (16)
(8)Lens (13, 55)
(9)Lens cover (3)
(10)Intake vents
(11)Filter cover (54)
The air filter and intake vent are inside.
(12)Exhaust vents
(13)AC inlet (10)
(14)VIDEO port (8)
(15)
(16)Security slot (10)
(17)COMPUTER IN1 port (8)
(18)Shutdown switch (58)
(19)COMPUTER IN2 port (8)
(20)USB port (8)
(21)HDMI port (8)
(22)AUDIO IN port (8)
(23)AUDIO OUT port (8)
HOT! (1) | (2) (3) (4) |
(5)
(7) | (10) |
|
| (6) | |
| (9) (8) | (11) | (7) | ||
(Bottom) | |||||
| |||||
(13)
(12)
HOT!
(14)(15) (16) (17) (18) (19) (20) (21) (23) (22)
| COMPUTER IN1 COMPUTER IN2 | USB | HDMI | AUDIO OUT |
|
|
| ||
|
|
|
| |
|
|
| AUDIO IN | |
K |
|
|
| |
VIDEO |
|
|
|
|
WARNING ►HOT! : Do not touch around the lamp cover and the exhaust vents during use or just after use, since it is too hot.
►Do not look into the lens or vents while the lamp is on, since the strong light is not good for your eyes.
►Do not handle the elevator knobs without holding the projector, since the projector may drop down.
CAUTION ►Maintain normal ventilation to prevent the projector from heating up. Do not cover, block or plug up the vents. Do not place anything that can stick or be sucked to the vents, around the intake vents. Clean the air filter periodically.
►Do not use the security slot to prevent the projector from falling down, since it is not designed for it.
►Use the shutdown switch only when the projector is not turned off by normal procedure, since pushing this switch stops operation of the projector without cooling it down.