Rackmount Solutions VA 6000, VA 3000, VA 700, VA 10000, VA 20000 manual Modes of Operation

Page 46

14.3 Modes of Operation

There are three modes of operation, when the UPS is switched on.

14.3.1 Normal Operation, Inverter On (Mains Available)

Lights Illuminated

Fig. 30: Front Display Panel During Normal Operations (Mains Available)

The loads are supplied through the inverter, the energy is taken from the mains.

14.3.2 Battery Operation, Inverter On (Mains Failure)

Lights Illuminated

During Power Failure

Fig. 31: Front Display Panel During Battery Operation (Mains Failure)

In the event of a mains failure, the inverter continues to supply the loads uninterruptedly, the energy is taken from the battery.

In this operation mode, an acoustical signal is given in intervals of approximately 4 seconds. When reaching the battery’s energy minimum, this signal is given every second.

42

Chloride Active and E-Series UPS User Manual

Page 45 Page 47
Image 46
Page 45 Page 47
Contents
Page Important Safety Instructions FCC ComplianceChloride Introduction Operational Characteristics E-Series Chloride Introduction Technical Support and Service ActiveSafety Notes Registering your Chloride Active UPSPage Display and Operation Elements Active Overload LoadFront Rear Active 700Active 2000 Active 3000 Rear ViewInstallation and operating notes SafetyActive Rackmount Series Type of Battery Packs Maximum Number of Packs Connection of a battery packBattery Cabinets Mechanical AttachmentUnit Rear View and Connections Active 700-19 and Active Active700-19Active 2000-19 and Active Active3000-19Active Installation and Commissioning External Battery Packs Commissioning of an External Battery CabinetModel Cabinet Batteries Operational Characteristics Active Ready for Operation Check Self TestModes of Operation Battery Operation, Inverter On Mains FailureNormal Operation, Inverter On Mains Available Bypass Operation, Inverter OFF Overload 140% Front Display Panel During Bypass Operation Overload 140%Description of the Interface Active Standard Interface COM aInterface COM a Optional Interface COM BPin Number Condition INV Shutdown Cleaning Maintenance ActiveStorage Troubleshooting Troubleshooting ActiveProblem Possible Cause Action to Take Page Active Tower and Rackmount Specifications Chloride Active UPS North AmericaUPS Model Active Battery extensionSignals Mechanical DataUPS Model Active Connections Mains connections Load connectionActive Rackmount Technical Data for North American Models Operating DataBattery Lifetime Typical lifetime of the batteriesTechnical Support and Service E-Series Registering your Chloride E-Series UPSPage Display and Operation Elements E-Series Switch for at least 1 second. a tone sounds Series E61 and E101 E41 or E61Series E203 E81 or E101Series Installation and Commissioning Installation of the E-Series HardwiredPage Minimum Requirements for E-Series UPS Installation Lbs AwgWiring Diagram for the E101 Commissioning of the E-Series Starting Up the E-Series Dryers, vacuum cleaners BPE61 Technical data of the connection cable E101 E203Self Test Modes of Operation Bypass Operation, Inverter OFF Overload 140% Description of the Interface E-Series Optional Interface COM B Emergency Power Off EPO Series Models E153X and E203X onlyMaintenance E-Series Troubleshooting E-Series Page Series Specifications Chloride E-Series UPS North AmericaBPE101 Weight lbs 337 894 Dimensions HxWxD in. mm E101XA E203XA E41XA E81 E153XA Connections Optional Power Distribution Units PDU available 4 -10 kVA Optional Power Distribution UnitsChloride Power Protection
Top Page Image Contents