Mitsubishi Electronics XD95U user manual Advanced

Page 31

	Quick Cooling		On/Off
	High Altitude Mode		On/Off
		Menu display time	5 sec/10 sec/15 sec/20 sec/25 sec/30 sec
	Menu Settings	Menu position	Center/Top-Left/Top-Right/Bottom-Left/
5.		Menu position	Bottom-Right
5.			Bottom-Right
SYSTEM SETUP:		Lamp mode	Standard/Low
Advanced	Lamp Settings	Reset lamp timer
		Equivalent lamp hour
	Security Settings	Change password
	Security Settings	Power on lock	On/Off
		Power on lock	On/Off
	Reset All Settings
			•	Source
6. INFORMATION			•	Setting
6. INFORMATION	Current System Status		•	Resolution
			•	Color System
			•	Equivalent Lamp Hour

Note that the menu items are available when the projector detects at least one valid signal. If there is no equipment connected to the projector or no signal detected, limited menu items are accessible.

ENGLISH

EN-31

Image 31

Contents XD95U Shock EN-3 Contents Important safeguards Compliance Notice of Industry Canada External control panel Projector exterior viewKensington Lock Front/upper sideProjector Controls and functionsFreeze Remote controlPull out the battery holder Remote control effective rangeChoosing a location Positioning your projectorObtaining a preferred projected image size EN-12 169 Layout of the projectorFront projection StandardConnecting Video source devices Connecting a computerConnection To connect the projector to an S-Video source device Connecting a Component Video source deviceConnecting an S-Video source device To connect the projector to a Component Video source deviceTo connect the projector to a composite Video source device Connecting a composite Video source deviceStarting up the projector OperationUse / to highlight the System Setup Basic menu Using the menusEntering the password recall procedure Utilizing the password functionSetting a password If you forget the passwordEnter the old password Switching input signalChanging the password Disabling the password functionFine-tuning the image size and clarity Adjusting the projected imageAdjusting the projection angle Auto-adjusting the imageCorrecting keystone Magnifying and searching for detailsAltering the images aspect ratio Selecting the aspect ratioOptimizing the image Selecting a picture modePicture modes for different types of signals Setting the User 1/User 2 modeFine-tuning the image quality in user modes 3D Color Management Using Wall ColorPress MODE/ENTER and the 3D Color Management page displays To cancel the timer, perform the following steps Setting the presentation timerHow to use the Timer On key? Freezing the image Setup Basic Panel Key Lock menu, and select On by pressingHiding the image Locking control keysShutting down the projector To activate the High Altitude ModeOperating in a high altitude environment Personalizing the projector menu displayBasic Menu operationMenu system Main menu Sub-menu OptionsAdvanced Description of each menu Timer Controller Presentation TimerAuto Power Off Blank TimerSetup menu Reset All Settings Security SettingsCurrent System Status Care of the projector MaintenanceGetting to know the lamp hour Setting Lamp mode as LowSetting Auto Power Off Lamp informationProjector until the 2950 hour lamp warning appears Timing of replacing the lampLamp has been in operation for 3000 hours Spare lamp for XD95U VLT-XD95LP Replacing the lampTighten the screw that secures the lamp Resetting the lamp timerRestart the projector Please contact your dealer for assistance IndicatorsDown without the normal cooling down process Projector needs 90 seconds to cool downTroubleshooting Projector specifications SpecificationsTiming chart DimensionsSupported timing for Component-YPbPrinput Mitsubishi Electric Corporation

SYSTEM SETUP:

Advanced