Planar PR3020, PR5020 manual Setup And Operation, Inserting the Remote Control Batteries

Page 18

SETUP AND OPERATION

SETUP AND OPERATION

Inserting the Remote Control Batteries

1. Remove the battery compartment cover by sliding the cover in the direction of the arrow.

2. Insert the supplied batteries taking note of the polarity (+/-) as shown here.

3. Replace the cover.

Caution:

1.Only use AAA alkaline batteries.

2.Dispose of used batteries according to local ordinance regulations.

3.Remove the batteries when not using the projector for prolonged periods.

– 10 –

Image 18

Contents Page Corporate Headquarters 1195 NW Compton Drive Beaverton, OR Planar Systems, IncPlanar Customer Support Telephone US 1-866-PLANAR1 866 Outside US 503Disclaimer User’s ManualCopyright Trademark RecognitionRemote Control Important Safety InformationSymbols Used General Safety InformationSymbol Explanations Power SafetyCleaning the Projector Replacing the LampAbout this manual Main FeaturesCables, Replacement Lamps and Accessories Register Your Planar Products TodayON-SCREEN DISPLAY OSD MENU SETTINGS Table of contentsSETUP AND OPERATION MAINTENANCE AND SECURITYTIMING MODE TABLE SAFETY CERTIFICATIONSPR5020 Projection distance and size table REGULATORY COMPLIANCEPacking Checklist GETTING STARTEDAvoid using the projector in dusty environments Front-right View Views of Projector PartsTop view-On-screen Display OSD buttons and LEDs Height-adjuster buttonPush to release height adjuster DLP Projector - User’s ManualUser’s Manual Rear view Secure to permanent object with a Kensington Lock Bottom viewSecurity Lock systemRemote Control Parts Page down when connected through USB to a PC Page DownRemote Control Operating Range Projector and Remote Control ButtonsSETUP AND OPERATION Inserting the Remote Control BatteriesConnecting Input Devices User’s Manual Starting and Shutting down the Projector Turn off the main Power switch when the Ready LED stops flashing Setting an Access Password Security Lock Adjusting the Projector Level Adjusting the Zoom, Focus and Keystone Adjusting the VolumeUse the Keystone button to correct image distor- tion ON-SCREEN DISPLAY OSD MENU SETTINGS Navigating the OSDOSD Menu Controls Setting the OSD Language Setting the OSD Language Main Menu InputGamma Main Menu Functions Available for Connected Source x = available to video sourceSetup Menu Functions Available for Connected Source Setup MenuAdvance Feature Data sourceDLP Projector - User’s Manual User Color Config Menu The Config menu functions are available to all video sourcesUtility Menu Utility Menu Functions Available for Connected Source Tool Menu Status Menu TheseMAINTENANCE AND SECURITY Replacing the Projection Lamp2. Open the lamp com- partment cover B 3. Remove the two screws from the lamp module C4. Lift the module handle up D Reverse steps 1 to 5 to install the new lamp module Pull firmly on the mod- ule handle to remove the lamp module DResetting the Lamp Cleaning the ProjectorCleaning the Lens Cleaning the CaseUsing the Kensington Lock TROUBLESHOOTING Common problems and solutionsTips for Troubleshooting Problem No image appears on the screen LED Error MessagesImage Problems Problem The image is blurredAudio Problems Lamp ProblemsRemote Control Problems Problem The image is flat with no contrastPR3010 SPECIFICATIONSInput/output connectors PR3020PR3020 and PR3010 Projection distance and size table Projection Distance V.S. Projection SizeL Projection Distance PR5020 Projection distance and size table Shaded rows are equivalent measurement in feet and inchesResolution Timing Mode TableSignal VideoProjector Dimensions 300 mm11.8 mm396 244 mm9.6FCC Warning Safety CertificationsREGULATORY COMPLIANCE CanadaPlanar Systems, Inc Planar Customer Support