Planar PR5020, PR3020 manual DLP Projector - User’s Manual, Open the lamp com- partment cover B

Page 41

2. Open the lamp com- partment cover (B).

DLP® Projector – User’s Manual

2. Open the lamp com- partment cover (B).

3. Remove the two screws from the lamp module (C). B

3. Remove the two screws from the lamp module (C).

4. Lift the module handle up (D).

– 33 –

Image 41

Contents Page Planar Customer Support Planar Systems, IncCorporate Headquarters 1195 NW Compton Drive Beaverton, OR Telephone US 1-866-PLANAR1 866 Outside US 503Copyright User’s ManualDisclaimer Trademark RecognitionSymbols Used Important Safety InformationRemote Control General Safety InformationCleaning the Projector Power SafetySymbol Explanations Replacing the LampCables, Replacement Lamps and Accessories Main FeaturesAbout this manual Register Your Planar Products TodaySETUP AND OPERATION Table of contentsON-SCREEN DISPLAY OSD MENU SETTINGS MAINTENANCE AND SECURITYPR5020 Projection distance and size table SAFETY CERTIFICATIONSTIMING MODE TABLE REGULATORY COMPLIANCEAvoid using the projector in dusty environments Packing ChecklistGETTING STARTED Views of Projector Parts Front-right ViewPush to release height adjuster Height-adjuster buttonTop view-On-screen Display OSD buttons and LEDs DLP Projector - User’s ManualUser’s Manual Rear view Security Lock Bottom viewSecure to permanent object with a Kensington Lock systemRemote Control Parts Page Down Page down when connected through USB to a PCProjector and Remote Control Buttons Remote Control Operating RangeInserting the Remote Control Batteries SETUP AND OPERATIONConnecting Input Devices User’s Manual Starting and Shutting down the Projector Turn off the main Power switch when the Ready LED stops flashing Setting an Access Password Security Lock Adjusting the Projector Level Use the Keystone button to correct image distor- tion Adjusting the Zoom, Focus and KeystoneAdjusting the Volume OSD Menu Controls ON-SCREEN DISPLAY OSD MENU SETTINGSNavigating the OSD Setting the OSD Language User’s Manual Gamma Main MenuInput x = available to video source Main Menu Functions Available for Connected SourceSetup Menu Setup Menu Functions Available for Connected SourceData source Advance FeatureDLP Projector - User’s Manual User Color The Config menu functions are available to all video sources Config MenuUtility Menu Utility Menu Functions Available for Connected Source Tool Menu These Status MenuReplacing the Projection Lamp MAINTENANCE AND SECURITY4. Lift the module handle up D 2. Open the lamp com- partment cover B3. Remove the two screws from the lamp module C Pull firmly on the mod- ule handle to remove the lamp module D Reverse steps 1 to 5 to install the new lamp moduleCleaning the Projector Resetting the LampUsing the Kensington Lock Cleaning the LensCleaning the Case Tips for Troubleshooting TROUBLESHOOTINGCommon problems and solutions Image Problems LED Error MessagesProblem No image appears on the screen Problem The image is blurredRemote Control Problems Lamp ProblemsAudio Problems Problem The image is flat with no contrastInput/output connectors SPECIFICATIONSPR3010 PR3020L Projection Distance PR3020 and PR3010 Projection distance and size tableProjection Distance V.S. Projection Size Shaded rows are equivalent measurement in feet and inches PR5020 Projection distance and size tableSignal Timing Mode TableResolution Video300 mm11.8 mm396 244 mm9.6 Projector DimensionsREGULATORY COMPLIANCE Safety CertificationsFCC Warning CanadaPlanar Customer Support Planar Systems, Inc