Planar PR3020 User’s Manual, Turn off the main Power switch when the Ready LED stops flashing

Page 22

Turn off the main Power switch when the Ready LED stops flashing.

User’s Manual

7.

8.

When the “Power Off?/Press Power again” message appears, press the Power button. The projector turns off.

Turn off the main Power switch when the Ready LED stops flashing.

Caution:

Do not unplug the power cord until the Ready LED stops flashing, indicating the projector has cooled down.

– 14 –

Image 22

Contents Page Corporate Headquarters 1195 NW Compton Drive Beaverton, OR Planar Systems, IncPlanar Customer Support Telephone US 1-866-PLANAR1 866 Outside US 503Disclaimer User’s ManualCopyright Trademark RecognitionRemote Control Important Safety InformationSymbols Used General Safety InformationSymbol Explanations Power SafetyCleaning the Projector Replacing the LampAbout this manual Main FeaturesCables, Replacement Lamps and Accessories Register Your Planar Products TodayON-SCREEN DISPLAY OSD MENU SETTINGS Table of contentsSETUP AND OPERATION MAINTENANCE AND SECURITYTIMING MODE TABLE SAFETY CERTIFICATIONSPR5020 Projection distance and size table REGULATORY COMPLIANCEGETTING STARTED Packing ChecklistAvoid using the projector in dusty environments Front-right View Views of Projector PartsTop view-On-screen Display OSD buttons and LEDs Height-adjuster buttonPush to release height adjuster DLP Projector - User’s ManualUser’s Manual Rear view Secure to permanent object with a Kensington Lock Bottom viewSecurity Lock systemRemote Control Parts Page down when connected through USB to a PC Page DownRemote Control Operating Range Projector and Remote Control ButtonsSETUP AND OPERATION Inserting the Remote Control BatteriesConnecting Input Devices User’s Manual Starting and Shutting down the Projector Turn off the main Power switch when the Ready LED stops flashing Setting an Access Password Security Lock Adjusting the Projector Level Adjusting the Volume Adjusting the Zoom, Focus and KeystoneUse the Keystone button to correct image distor- tion Navigating the OSD ON-SCREEN DISPLAY OSD MENU SETTINGSOSD Menu Controls Setting the OSD Language Setting the OSD Language Input Main MenuGamma Main Menu Functions Available for Connected Source x = available to video sourceSetup Menu Functions Available for Connected Source Setup MenuAdvance Feature Data sourceDLP Projector - User’s Manual User Color Config Menu The Config menu functions are available to all video sourcesUtility Menu Utility Menu Functions Available for Connected Source Tool Menu Status Menu TheseMAINTENANCE AND SECURITY Replacing the Projection Lamp3. Remove the two screws from the lamp module C 2. Open the lamp com- partment cover B4. Lift the module handle up D Reverse steps 1 to 5 to install the new lamp module Pull firmly on the mod- ule handle to remove the lamp module DResetting the Lamp Cleaning the ProjectorCleaning the Case Cleaning the LensUsing the Kensington Lock Common problems and solutions TROUBLESHOOTINGTips for Troubleshooting Problem No image appears on the screen LED Error MessagesImage Problems Problem The image is blurredAudio Problems Lamp ProblemsRemote Control Problems Problem The image is flat with no contrastPR3010 SPECIFICATIONSInput/output connectors PR3020Projection Distance V.S. Projection Size PR3020 and PR3010 Projection distance and size tableL Projection Distance PR5020 Projection distance and size table Shaded rows are equivalent measurement in feet and inchesResolution Timing Mode TableSignal VideoProjector Dimensions 300 mm11.8 mm396 244 mm9.6FCC Warning Safety CertificationsREGULATORY COMPLIANCE CanadaPlanar Systems, Inc Planar Customer Support