Onkyo HT-S5300 instruction manual Connecting the Speaker Cables, To 5/812 to 15 mm

Page 13

Connecting the Speaker Cables

Screw-type speaker terminals

Strip 1/2" to 5/8" (12 to 15 mm) of

1/2" to 5/8"(12 to 15 mm)

insulation from the ends of the

 

speaker cables, and twist the bare

 

wires tightly, as shown. (Supplied

 

speaker cables are already stripped.)

 

Using Banana Plugs (North American models)

If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.

Do not insert the speaker code directly into the center hole of the speaker terminal.

Push-type speaker terminals

Strip 3/8" to 1/2" (10 to 12 mm) of insulation from the ends of

3/8" to 1/2"(10 to 12 mm)

the speaker cables, and twist the bare wires tightly, as shown.

 

 

 

 

 

 

 

 

 

 

 

(Supplied speaker cables are already stripped.)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The following illustration shows which speaker should be connected to each pair of terminals. If you’re using only one surround back speaker, connect it to the SURR BACK OR FRONT HIGH L terminals.

Surround

Surround

Surround

Surround

back right

back left

right

 

left

speaker

speaker

speaker

speaker

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Tan

Brown

Gray

Blue

Front

Front

right

left

speaker

speaker

Red

 

Center speaker

White Green

Front high

Front high

 

right

left

 

speaker

speaker

Powered

(Optional)

(Optional)

subwoofer

* Using the supplied RCA cable, connect the subwoofer’s LINE INPUT jack to your AV receiver’s SUBWOOFER PRE OUT jack.

En

13

Image 13
Contents HT-S5300 10 cm 4 at the rear. The rear edge of the shelf or Always consider the environmental issues and followBoard above the apparatus shall be set 10 cm Away from the rear panel or wall, creating a flue-likePrecautions Speaker Precautions Package Contents Contents AV Receiver HT-R580 FeaturesSpeaker Package HTP-580 Front Panel Front & Rear PanelsUREMOTE Control jack Power cordDisplay Rear PanelSubwoofer SKW-580 Speaker PackageControlling the AV Receiver Remote ControllerReturn button Controlling the tunerEnjoying Home Theater About Home TheaterConnecting Your Speakers Connecting the AV ReceiverSpeaker Configuration Speaker Connection PrecautionsScrew-type speaker terminals Strip 1/2 to 5/8 12 to 15 mm Connecting the Speaker CablesTo 5/812 to 15 mm Using the Floor Pads for Subwoofer Using the Rubber Stoppers for a More Stable PlatformWall Mounting Connected image with AV components About AV ConnectionsAV Cables and Jacks Hdmi cableJack Signal Components Assignable Connecting Components with HdmiAudio return channel ARC function How to record the video Connecting External ComponentsConnecting Onkyo uComponents Using the AUX Input jacks on the front panelSystem On/Auto Power On Remote ControlNorth American models Asian models Connecting AntennaAssembling the AM loop antenna Which Connections Should I Use? On-screen setup menus are displayed whenVideo Connection Formats Audio Connection FormatsTurning On Turning On/Off the AV ReceiverTurning Off Setting the Display Brightness Using the Music OptimizerBasic Operations Playing the Connected ComponentUsing Headphones Using the Sleep TimerMuting the AV Receiver Changing the Input DisplayTuning into Radio Stations Using the TunerListening to the Radio Listening to the RadioUsing RDS excluding North American models Presetting FM/AM StationsSelecting Presets Deleting PresetsFinding Stations by Type PTY Displaying Radio Text RTListening to Traffic News TP RDS program types PTYAV Recording RecordingThat you want to record On your recorder, start recordingListening Mode Buttons Using the Listening ModesSelecting Listening Modes Explanatory Notes About Listening ModesInput Source Speaker LayoutListening Modes Dolby Digital Plus *5 Resolution AudioDolby TrueHD DTS-HD HighUnplugged Onkyo-Original DSP Listening ModesOn-screen Setup Menus Common Procedures in Setup Menu Advanced SetupComponent Component Video Input Hdmi InputDigital Audio Digital Audio Input SubwooferFront Sp Config Speaker ConfigurationSurrBack Ch Crossover Crossover FrequencyMultiplex/Mono Settings Audio AdjustDolby Settings Sp Distance Speaker DistanceAudyssey Settings DTS SettingDynamic Volume Theater-Dimensional SettingReference Level Listening AngleRemote Control Settings Speaker SettingsFM/AM Frequency Setup Settings Name EditHdmi Setup Tone Control Settings Using the Audio SettingsSpeaker Levels Music Optimizer Late Night FunctionCinemaFILTER Audio SelectorAdjusting the Bass & Treble Digital Input Signal FormatsSync SyncConnecting Your Zone 2 Speakers Directly to the AV receiver Connecting ZoneConnecting Your Zone 2 Speakers to an Amp in Zone ZoneControlling Zone 2 from the AV receiver Setting the Powered Zone Using ZoneFront High or ZONE2 L/R speaker ter Adjusting the Volume for Zone Controlling Zone 2 with the Remote ControllerOperating with the remote controller Muting ZonesControlling iPod Connecting an Onkyo DockModels sold are different depending on the region Onkyo Dock CableUP-A1 Dock Using the Onkyo DockRI Dock Controlling Your iPodWithout the RI Control With the RI ControlAvailable buttons Entering Remote Control Codes Preprogrammed Remote Control CodesRemote Control Codes for Onkyo Components Connected via u Controlling Other ComponentsResetting the Remote Controller Resetting Remote Mode ButtonsYou can reset the remote controller to its default settings Controlling Other ComponentsTV VOL q/w Cassettetape deckCH + Disc + Standby indicator flashes red TroubleshootingCan’t turn on the AV receiver There’s no sound, or it’s very quietVolume cannot be set to There’s no sound with a certain signal formatAbout DTS signals Only the center speaker produces soundAV receiver’s remote controller doesn’t control your iPod Remote controller doesn’t workThere’s no picture from a source connected to an Hdmi On-screen menus don’t appearCan’t record Sound changes when I connect my headphonesHow do I change the language of a multiplex source Ufunctions don’t workAV receiver SpecificationsSubwoofer SKW-580 1ch Home Theater Speaker PackageFront Speaker SKF-580 Center Speaker SKC-580Supported Audio Formats About HdmiAbout Copyright Protection About p-compatible components Using an RIHD-compatible TV, Player, or RecorderOperations that can be performed with p connection Confirm the connecting and setting How to connect and setupConfirm the settings Operate with the remote controllerMemo Onkyo Europe Electronics GmbH UK Branch Onkyo Europe Electronics GmbH

HT-S5300 specifications

The Onkyo HT-S5300 is a home theater system that aims to enhance the cinematic experience in the comfort of your own home. This system is particularly appealing to movie enthusiasts and gamers alike, providing a rich and immersive sound environment that elevates any viewing experience.

At the heart of the HT-S5300 is its 5.1-channel receiver, which is capable of delivering dynamic sound and powerful audio performance. With a total power output of 650 watts, the system can fill a room with vibrant sounds, making it ideal for both quiet movie nights and intense gaming sessions. The receiver includes several advanced audio decoding formats, including Dolby TrueHD and DTS-HD Master Audio, ensuring high-definition audio that is faithful to the original recordings.

One of the standout features of the HT-S5300 is its integrated Audyssey technology. This feature employs sophisticated algorithms that automatically calibrate the audio output based on the unique acoustics of your room. As a result, it provides optimal sound performance, allowing users to enjoy their content with impressive clarity and depth.

The HT-S5300 also includes multiple HDMI inputs, allowing users to connect a variety of devices such as Blu-ray players, gaming consoles, and streaming devices seamlessly. The Audio Return Channel (ARC) ensures that audio from compatible televisions can be sent back to the receiver without needing additional cables, simplifying the setup process.

In addition to digital audio and video capabilities, the HT-S5300 supports wireless streaming through Bluetooth technology. This feature allows users to effortlessly play music from their smartphones, tablets, or other devices directly through the home theater system, broadening the entertainment options available.

The package also includes five compact satellite speakers and a powerful subwoofer, which work together to create a balanced and immersive surround sound environment. The sleek design with a black finish ensures that the speakers can blend seamlessly into any home decor.

Overall, the Onkyo HT-S5300 stands out as a versatile and feature-rich home theater system that combines advanced audio technologies with user-friendly functionality. Whether for movie watching, music listening, or gaming, the HT-S5300 delivers an impressive auditory experience that is sure to satisfy any entertainment enthusiast.