Onkyo HT-S5300 instruction manual Name Edit, Hardware, Speaker Settings, Remote Control Settings

Name Edit

Menu Name Edit

You can enter a preset name for each individual input selector for easy identification. When entered, the preset name will appear on the display.

Preparation

Press the input selector buttons to select an input source.

■Name

`- - -,Blu-ray,DVD, HD DVD, VCR, DVR, Tivo, CableSTB, SAT STB, PS3, Wii, Xbox, PC, TV, CD, TAPE, iPod:

To reset to the default, select “- - -”.

Note

•Can not set the input selector by the same name.

•This menu cannot be used for the TUNER input selector.

Hardware

Menu Hardware

Speaker Settings

If the impedance of any speaker is 4 ohms or more but less than 6, set the minimum speaker impedance to 4 ohms.

Note

• Before you change these settings, turn down the volume.

■Sp Impedance

`4ohms:

Select if the impedance of any speaker is 4 ohms or more but less than 6.

`6ohms:

Select if the impedances of all speakers are between 6 and 16 ohms.

Note

•(North American models) Do not support speakers with an impedance of less than 6 ohms.

■Front High/Zone2

`Front High:

Front high speakers can be used.

`Zone2:

Zone2 speakers can be used.

Select “Zone2” if you’ve connected your Zone 2 speakers

to FRONT HIGH OR ZONE 2 SPEAKERS L/R termi-

nals (➔ 44).

■SurrBk/FrontHigh

`Front High:

Front high speakers can be used.

`SurrBack:

Surround back speakers can be used.

Select “Front High” if you’ve connected your Zone 2 speakers to FRONT HIGH OR ZONE 2 SPEAKERS L/ R terminals, and the front high speakers to SURR BACK OR FRONT HIGH SPEAKERS L/R terminals.

Note

•If the “Front High/Zone2” setting is set to “Front High”, this setting is set to “SurrBack”.

Remote Control Settings

■Remote ID

`1, 2, or 3

When several Onkyo components are used in the same room, their remote ID codes may overlap. To differenti- ate the AV receiver from the other components, you can change its remote ID from “1”, to “2” or “3”.

Note

•If you do change the AV receiver’s remote ID, be sure to change the remote controller to the same ID (see below), otherwise, you won’t be able to control it with the remote controller.

Changing the Remote Controller’s ID

1 While holding down RECEIVER, press and hold down SETUP until the remote indicator lights (about 3 seconds).

2 Use the number buttons to enter ID 1, 2, or 3.

The remote indicator flashes twice.

FM/AM Frequency Setup Settings

For FM/AM tuning to work properly, you must specify the FM/AM frequency step used in your area. Note that when this setting is changed, all radio presets will be deleted.

■FM/AM Freq Step (North American models)

`200k/10kHz:

Select if 200 k/10 kHz steps are used in your area.

`50k/ 9kHz:

Select if 50 k/9 kHz steps are used in your area.

■AM Freq Step (Asian models)

`10kHz:

Select if 10 kHz steps are used in your area.

`9kHz:

Select if 9 kHz steps are used in your area.

En

39