Hasselblad 848 manual Unmounting the Batch Feeder

Page 12

Unmounting the Batch Feeder

12

Unmounting the Batch Feeder

Always use the software-guided procedure below to unmount the Feeder. It is otherwise possible to damage the Feeder and/or scanner while un- mounting the Feeder

1.Turn on the scanner and launch the FlexColor software.

2.Select Maintenance > Feeder from the menu bar.

3.The Feeder window opens.

Press the Unmount button.

4.The feeder moves the magazine into its storage position and FlexColor displays the Mount feeder window.

As instructed in the window, click Continue to prepare the scanner and Feeder for unmounting.

Image 12

Contents by Hasselblad User’s GuideBatch Feeder for Flextight 848 and 949 Scanners Page Table of Contents Introduction Important Warnings and RestrictionsGeneral System Requirements When Operating the FeederFor All Users For Macintosh UsersBatch Feeder Diagram A C D EB F G H Preparing the Feeder for First Use or after Shipping Figure 2 Location of the shipping screws on the Feeder back panelMounting and Unmounting the Batch Feeder Mounting the Batch Feeder5. The Feeder window opens Click on the Mount button Click on the Continue buttonPage 11. Turn on the scanner by pressing its on/off switch Click on Done to close the Mount feeder windowUnmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Scanning with the Batch Feeder Batch Scanning with 3fPage Page Custom Setups and Single Scans Page Page Troubleshooting Adjusting the Feeder Angle Aligning the FeederFigure 6 Adjusting the Feeder angle Adjusting the Loading Position Figure 7 Bolts for adjusting the feeder angleNOTE! Do not touch similar looking nuts to the left Figure 8 Unlocking/locking the Feeder positionYou have already loosened the nut, so just click on Continue Figure 9 Using the adjustment tool Figure 10 Adjusting the Feeder position10. Re-mount the Feeder on your scanner and then turn on the scanner 13. You now return to the Feeder window Click on Done to close the Feeder windowPreparing the Feeder for Storage or Shipping Storing the FeederShipping the Feeder 4. Get the original box and lay down on the floor or on a table Preventive Maintenance DisposalSpecifications Technical InformationCE Declaration