Hasselblad 848 manual Adjusting the Loading Position, Bolts for adjusting the feeder angle

Page 25

Figure 7: Bolts for adjusting the feeder angle

25

Figure 7: Bolts for adjusting the feeder angle

7.Use your fingers to turn the two adjustment bolts until that they look as though they will hold the bottom of the Feeder at the correct angle.

8.Use the software-assisted procedure to remount the Feeder to the scanner as described in “Mounting the Feeder” on page 8.

9.Check to see if the angle now looks correct. If not, then repeat this procedure until the angle is correct (always use the software-assisted procedure when mounting or unmounting the Feeder).

10.When the angle is set correctly, use the supplied adjustment tool to tighten the two nuts on the back of the adjustment bolts.

Adjusting the Loading Position

The Feeder must be positioned so that it inserts its original holders di- rectly into the clasp mounted on the drum inside the scanner. Use the procedure below only if your original holders are not being drawn in and out of the scanner smoothly during normal operation.

1.If the feeder is currently mounted, then use the software-assisted procedure to unmount the Feeder as described in “Unmounting the Feeder” on page 12.

Image 25

Contents User’s Guide by HasselbladBatch Feeder for Flextight 848 and 949 Scanners Page Table of Contents Important Warnings and Restrictions IntroductionGeneral When Operating the Feeder System RequirementsFor All Users For Macintosh UsersA C D E Batch Feeder DiagramB F G H Figure 2 Location of the shipping screws on the Feeder back panel Preparing the Feeder for First Use or after ShippingMounting the Batch Feeder Mounting and Unmounting the Batch FeederClick on the Continue button 5. The Feeder window opens Click on the Mount buttonPage Click on Done to close the Mount feeder window 11. Turn on the scanner by pressing its on/off switchUnmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Batch Scanning with 3f Scanning with the Batch FeederPage Page Custom Setups and Single Scans Page Page Troubleshooting Aligning the Feeder Adjusting the Feeder AngleFigure 6 Adjusting the Feeder angle Figure 7 Bolts for adjusting the feeder angle Adjusting the Loading PositionFigure 8 Unlocking/locking the Feeder position NOTE! Do not touch similar looking nuts to the leftYou have already loosened the nut, so just click on Continue Figure 10 Adjusting the Feeder position Figure 9 Using the adjustment tool10. Re-mount the Feeder on your scanner and then turn on the scanner Click on Done to close the Feeder window 13. You now return to the Feeder windowStoring the Feeder Preparing the Feeder for Storage or ShippingShipping the Feeder 4. Get the original box and lay down on the floor or on a table Disposal Preventive MaintenanceTechnical Information SpecificationsCE Declaration