Hasselblad 848 manual Using the adjustment tool, Adjusting the Feeder position

Page 28

Figure 9: Using the adjustment tool

28

Figure 9: Using the adjustment tool

7.Move the adjustment tool left and right to adjust the Feeder position so the Feeder is centered with reference to the grabber for the original holder inside the scanner (see also Figure 10).

X

X

Figure 10: Adjusting the Feeder position

8.When you have finished adjusting the Feeder, go back to your com- puter and click on Continue in the Align Feeder window.

Image 28

Contents User’s Guide by HasselbladBatch Feeder for Flextight 848 and 949 Scanners Page Table of Contents Important Warnings and Restrictions IntroductionGeneral System Requirements When Operating the FeederFor All Users For Macintosh UsersA C D E Batch Feeder DiagramB F G H Preparing the Feeder for First Use or after Shipping Figure 2 Location of the shipping screws on the Feeder back panelMounting and Unmounting the Batch Feeder Mounting the Batch Feeder5. The Feeder window opens Click on the Mount button Click on the Continue buttonPage 11. Turn on the scanner by pressing its on/off switch Click on Done to close the Mount feeder windowUnmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Scanning with the Batch Feeder Batch Scanning with 3fPage Page Custom Setups and Single Scans Page Page Troubleshooting Adjusting the Feeder Angle Aligning the FeederFigure 6 Adjusting the Feeder angle Adjusting the Loading Position Figure 7 Bolts for adjusting the feeder angleNOTE! Do not touch similar looking nuts to the left Figure 8 Unlocking/locking the Feeder positionYou have already loosened the nut, so just click on Continue Figure 9 Using the adjustment tool Figure 10 Adjusting the Feeder position10. Re-mount the Feeder on your scanner and then turn on the scanner 13. You now return to the Feeder window Click on Done to close the Feeder windowStoring the Feeder Preparing the Feeder for Storage or ShippingShipping the Feeder 4. Get the original box and lay down on the floor or on a table Preventive Maintenance DisposalSpecifications Technical InformationCE Declaration