Hasselblad 848 manual Preventive Maintenance, Disposal

Page 33

Preventive Maintenance

33

Preventive Maintenance

All Flextight scanners should be serviced every 25,000 scans or every 12 months, whichever comes first. If a Feeder is mounted, the recommended number of scans is 15,000 provided that the feeder is mounted for all scans. Please note that previews are also counted as scans.

Newer Flextight scanners have a counter installed so that the number of scans can be monitored from FlexColor. Please refer to the FlexColor manual to learn more about monitoring the number of scans.

Failures or faults originating from lack of service and/or daily mainte- nance are not covered by the factory warranty.

Disposal

If you need to dispose of the Feeder, it must be delivered to an authorized waste plant for electronics equipment.

Image 33

Contents by Hasselblad User’s GuideBatch Feeder for Flextight 848 and 949 Scanners Page Table of Contents Introduction Important Warnings and RestrictionsGeneral When Operating the Feeder System RequirementsFor All Users For Macintosh UsersBatch Feeder Diagram A C D EB F G H Figure 2 Location of the shipping screws on the Feeder back panel Preparing the Feeder for First Use or after ShippingMounting the Batch Feeder Mounting and Unmounting the Batch FeederClick on the Continue button 5. The Feeder window opens Click on the Mount buttonPage Click on Done to close the Mount feeder window 11. Turn on the scanner by pressing its on/off switchUnmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Batch Scanning with 3f Scanning with the Batch FeederPage Page Custom Setups and Single Scans Page Page Troubleshooting Aligning the Feeder Adjusting the Feeder AngleFigure 6 Adjusting the Feeder angle Figure 7 Bolts for adjusting the feeder angle Adjusting the Loading PositionFigure 8 Unlocking/locking the Feeder position NOTE! Do not touch similar looking nuts to the leftYou have already loosened the nut, so just click on Continue Figure 10 Adjusting the Feeder position Figure 9 Using the adjustment tool10. Re-mount the Feeder on your scanner and then turn on the scanner Click on Done to close the Feeder window 13. You now return to the Feeder windowPreparing the Feeder for Storage or Shipping Storing the FeederShipping the Feeder 4. Get the original box and lay down on the floor or on a table Disposal Preventive MaintenanceTechnical Information SpecificationsCE Declaration