Hasselblad 848 manual Loading Originals into the Feeder

Page 14

Loading Originals into the Feeder

14

Loading Originals into the Feeder

	C
	Pos. 1
A	Pos. 10

B

Figure 5: Loading originals into the Feeder

To load originals into Batch Feeder, refer to Figure 5 and do the follow- ing:

1.Important! Use only original holders (A) that are fitted with the special plastic rail (B), otherwise the Feeder will not be able to un- load the holder properly.

2.Place your original into an appropriate original holder (A). See your scanner documentation for a complete description of how to work with Flextight original holders.

3.Place the original holder (A) into the first empty slot in the Feeder magazine. Slide it gently into the slot until it comes to a stop. (To re- move the original holder, just slide it back out.)

NOTE! We recommend that you load original holders into the magazine from the top and down, starting from position 1.

Image 14

Contents Batch Feeder for Flextight 848 and 949 Scanners by HasselbladUser’s Guide Page Table of Contents General IntroductionImportant Warnings and Restrictions For All Users System RequirementsWhen Operating the Feeder For Macintosh UsersB F G H Batch Feeder DiagramA C D E Preparing the Feeder for First Use or after Shipping Figure 2 Location of the shipping screws on the Feeder back panelMounting and Unmounting the Batch Feeder Mounting the Batch Feeder5. The Feeder window opens Click on the Mount button Click on the Continue buttonPage 11. Turn on the scanner by pressing its on/off switch Click on Done to close the Mount feeder windowUnmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Scanning with the Batch Feeder Batch Scanning with 3fPage Page Custom Setups and Single Scans Page Page Troubleshooting Adjusting the Feeder Angle Aligning the FeederFigure 6 Adjusting the Feeder angle Adjusting the Loading Position Figure 7 Bolts for adjusting the feeder angleNOTE! Do not touch similar looking nuts to the left Figure 8 Unlocking/locking the Feeder positionYou have already loosened the nut, so just click on Continue Figure 9 Using the adjustment tool Figure 10 Adjusting the Feeder position10. Re-mount the Feeder on your scanner and then turn on the scanner 13. You now return to the Feeder window Click on Done to close the Feeder windowShipping the Feeder Preparing the Feeder for Storage or ShippingStoring the Feeder 4. Get the original box and lay down on the floor or on a table Preventive Maintenance DisposalSpecifications Technical InformationCE Declaration