Hasselblad 848 manual Preparing the Feeder for Storage or Shipping, Storing the Feeder

Page 31

Preparing the Feeder for

31

Preparing the Feeder for

Storage or Shipping

Storing the Feeder

To store the Feeder while it is not in use:

1.Detach the Feeder using the software-guided procedure given “Un- mounting the Batch Feeder” on page 12.

2.Retrieve the box in which your Feeder was originally delivered. This box is made of sturdy cardboard and includes a foam lining custom cut to hold the Feeder safely and securely.

3.Lay the box down on the floor or on a table.

4.Open the box, remove the top slab of foam and set it aside.

5.Align the Feeder so that it will fit into the cut foam.

6.Lower the Feeder into the box.

7.Replace the top slab and close the box.

The Feeder is now prepared for storage

Shipping the Feeder

If you need to ship the feeder, for example to a new studio or back to Has- selblad for service, then do the following:

1.Detach the Feeder using the software-guided procedure given “Un- mounting the Batch Feeder” on page 12.

2.Retrieve both the original shipping screws and storage/shipping box in which your Feeder was originally delivered.

Image 31

Contents User’s Guide by HasselbladBatch Feeder for Flextight 848 and 949 Scanners Page Table of Contents Important Warnings and Restrictions IntroductionGeneral For Macintosh Users System RequirementsWhen Operating the Feeder For All UsersA C D E Batch Feeder DiagramB F G H Figure 2 Location of the shipping screws on the Feeder back panel Preparing the Feeder for First Use or after ShippingMounting the Batch Feeder Mounting and Unmounting the Batch FeederClick on the Continue button 5. The Feeder window opens Click on the Mount buttonPage Click on Done to close the Mount feeder window 11. Turn on the scanner by pressing its on/off switchUnmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Batch Scanning with 3f Scanning with the Batch FeederPage Page Custom Setups and Single Scans Page Page Troubleshooting Aligning the Feeder Adjusting the Feeder AngleFigure 6 Adjusting the Feeder angle Figure 7 Bolts for adjusting the feeder angle Adjusting the Loading PositionFigure 8 Unlocking/locking the Feeder position NOTE! Do not touch similar looking nuts to the leftYou have already loosened the nut, so just click on Continue Figure 10 Adjusting the Feeder position Figure 9 Using the adjustment tool10. Re-mount the Feeder on your scanner and then turn on the scanner Click on Done to close the Feeder window 13. You now return to the Feeder windowStoring the Feeder Preparing the Feeder for Storage or ShippingShipping the Feeder 4. Get the original box and lay down on the floor or on a table Disposal Preventive MaintenanceTechnical Information SpecificationsCE Declaration