Hasselblad 848 manual Batch Feeder Diagram, A C D E, B F G H

Page 6

Batch Feeder Diagram

Batch Feeder Diagram

A

C

D

E

B

F

G

H

Figure 1: Hasselblad Flextight 848 Scanner with Batch Feeder

AHasselblad Flextight 848 (or 949) Scanner.

BBatch Feeder

CDust cover: to protect the originals and scanner entrance from dust.

DMagazine: showing original holder position 1.

EMagazine: showing original holder position 10.

FPower Indicator (Green): Remains lit when ready to scan. Flashes when the scanner is switched on.

GMotor Drive Indicator (Yellow): lights up when the scanner is repo- sitioning the optics, drum or Feeder magazine.

HScan Indicator (Red): lights up when scanning. Do not touch the scanner or Feeder while this indicator is lit. If the light is flashing when not scanning, then an error has occurred - please contact your Flextight dealer for assistance.

Image 6

Contents by Hasselblad User’s GuideBatch Feeder for Flextight 848 and 949 Scanners Page Table of Contents Introduction Important Warnings and RestrictionsGeneral For All Users System RequirementsWhen Operating the Feeder For Macintosh UsersBatch Feeder Diagram A C D EB F G H Preparing the Feeder for First Use or after Shipping Figure 2 Location of the shipping screws on the Feeder back panelMounting and Unmounting the Batch Feeder Mounting the Batch Feeder5. The Feeder window opens Click on the Mount button Click on the Continue buttonPage 11. Turn on the scanner by pressing its on/off switch Click on Done to close the Mount feeder windowUnmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Scanning with the Batch Feeder Batch Scanning with 3fPage Page Custom Setups and Single Scans Page Page Troubleshooting Adjusting the Feeder Angle Aligning the FeederFigure 6 Adjusting the Feeder angle Adjusting the Loading Position Figure 7 Bolts for adjusting the feeder angleNOTE! Do not touch similar looking nuts to the left Figure 8 Unlocking/locking the Feeder positionYou have already loosened the nut, so just click on Continue Figure 9 Using the adjustment tool Figure 10 Adjusting the Feeder position10. Re-mount the Feeder on your scanner and then turn on the scanner 13. You now return to the Feeder window Click on Done to close the Feeder windowPreparing the Feeder for Storage or Shipping Storing the FeederShipping the Feeder 4. Get the original box and lay down on the floor or on a table Preventive Maintenance DisposalSpecifications Technical InformationCE Declaration