Hasselblad 848 manual Preparing the Feeder for First Use or after Shipping

Page 7

Preparing the Feeder for First Use or after Shipping

Preparing the Feeder for First Use or after Shipping

Before you begin to use the Feeder, you must remove the two shipping screws that secure the magazine during shipping. They are located near the bottom of the Feeder on the back side, as shown in Figure 2, below. On new Feeders, these are clearly marked by a label, which reminds you to remove them before use.

Figure 2: Location of the shipping screws on the Feeder back panel

Be sure to keep both the original packaging and the two shipping screws in a safe place. You should always store the Feeder in its original packag- ing while you are not using it. You must also replace the shipping screws and use the original packaging if you need to ship the Feeder (for exam- ple, to a new studio or back to Hasselblad for service).

See also “Preparing the Feeder for Storage or Shipping” on page 31 for more information about how to ship the Batch Feeder.

Image 7

Contents User’s Guide by HasselbladBatch Feeder for Flextight 848 and 949 Scanners Page Table of Contents Important Warnings and Restrictions IntroductionGeneral For Macintosh Users System RequirementsWhen Operating the Feeder For All UsersA C D E Batch Feeder DiagramB F G H Figure 2 Location of the shipping screws on the Feeder back panel Preparing the Feeder for First Use or after ShippingMounting the Batch Feeder Mounting and Unmounting the Batch FeederClick on the Continue button 5. The Feeder window opens Click on the Mount buttonPage Click on Done to close the Mount feeder window 11. Turn on the scanner by pressing its on/off switchUnmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Batch Scanning with 3f Scanning with the Batch FeederPage Page Custom Setups and Single Scans Page Page Troubleshooting Aligning the Feeder Adjusting the Feeder AngleFigure 6 Adjusting the Feeder angle Figure 7 Bolts for adjusting the feeder angle Adjusting the Loading PositionFigure 8 Unlocking/locking the Feeder position NOTE! Do not touch similar looking nuts to the leftYou have already loosened the nut, so just click on Continue Figure 10 Adjusting the Feeder position Figure 9 Using the adjustment tool10. Re-mount the Feeder on your scanner and then turn on the scanner Click on Done to close the Feeder window 13. You now return to the Feeder windowStoring the Feeder Preparing the Feeder for Storage or ShippingShipping the Feeder 4. Get the original box and lay down on the floor or on a table Disposal Preventive MaintenanceTechnical Information SpecificationsCE Declaration