Hasselblad 848 manual Introduction, Important Warnings and Restrictions, General

Page 4
Introduction



Introduction

The Batch Feeder enables you to load up to 10 original holders (up to 60 originals, depending on format) for batch scanning with your Flextight 848 or 949 Scanner.

This manual provides important information about using the Batch Feeder for your Flextight 848 or 949 scanner.

Topics include:

•Important warnings and restrictions

•System requirements

•Installation instructions

•Operating instructions

•Instructions for preparing the unit for transportation

•Disposal instructions

Important Warnings and Restrictions

General

•Read all of the included documentation before attempting to install and use the Batch Feeder.

•Never attach or detach the Feeder when the scanner is switched on.

•Always use the standard, software-guided procedure when mounting or unmounting the Feeder from your scanner. See “Mounting and Unmounting the Batch Feeder” on page 8 for details.

•Keep the original box in which the Feeder was delivered to you. This box is made of sturdy cardboard and includes a foam lining custom cut to hold the Feeder safely and securely. Always store the Feeder in this box when you are not using it.

•Before shipping the Feeder, always refit the two transportation safety screws and pack it in its original box. If you must return the Feeder to Hasselblad for service, you must use this box for shipping or the ship- ment will be refused. See “Preparing the Feeder for Storage or Ship- ping” on page 31 for instructions.

Page 3 Page 5
Image 4
Page 3 Page 5
Contents User’s Guide by HasselbladBatch Feeder for Flextight 848 and 949 Scanners Page Table of Contents Important Warnings and Restrictions IntroductionGeneral System Requirements When Operating the FeederFor All Users For Macintosh UsersA C D E Batch Feeder DiagramB F G H Preparing the Feeder for First Use or after Shipping Figure 2 Location of the shipping screws on the Feeder back panelMounting and Unmounting the Batch Feeder Mounting the Batch Feeder5. The Feeder window opens Click on the Mount button Click on the Continue buttonPage 11. Turn on the scanner by pressing its on/off switch Click on Done to close the Mount feeder windowUnmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Scanning with the Batch Feeder Batch Scanning with 3fPage Page Custom Setups and Single Scans Page Page Troubleshooting Adjusting the Feeder Angle Aligning the FeederFigure 6 Adjusting the Feeder angle Adjusting the Loading Position Figure 7 Bolts for adjusting the feeder angleNOTE! Do not touch similar looking nuts to the left Figure 8 Unlocking/locking the Feeder positionYou have already loosened the nut, so just click on Continue Figure 9 Using the adjustment tool Figure 10 Adjusting the Feeder position10. Re-mount the Feeder on your scanner and then turn on the scanner 13. You now return to the Feeder window Click on Done to close the Feeder windowStoring the Feeder Preparing the Feeder for Storage or ShippingShipping the Feeder 4. Get the original box and lay down on the floor or on a table Preventive Maintenance DisposalSpecifications Technical InformationCE Declaration
Top Page Image Contents