Hasselblad 848 manual

Page 2

Manual background

© 2005 Hasselblad A/S. All rights reserved.

Feeder for Hasselblad Flextight 848 and 949 Scanners User’s Guide, Part No 70030031, revision E.

The information in this manual is furnished for informational use only, is subject to change with- out notice, and should not be construed as a commitment by Hasselblad A/S.

Hasselblad A/S assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual.

Hasselblad A/S assumes no responsibility or liability for loss or damage incurred during or as a result of using Hasselblad software or products.

Hasselblad, FlexColor and Flextight are trademarks of Hasselblad A/S. Adobe and Adobe Pho- toshop are trademarks of Adobe Systems, Inc. Macintosh, Mac OS, FireWire and ColorSync are registered trademarks of Apple Computer, Inc.

Printed in Denmark.

Image 2

Contents Batch Feeder for Flextight 848 and 949 Scanners by HasselbladUser’s Guide Page Table of Contents General IntroductionImportant Warnings and Restrictions For All Users System RequirementsWhen Operating the Feeder For Macintosh UsersB F G H Batch Feeder DiagramA C D E Preparing the Feeder for First Use or after Shipping Figure 2 Location of the shipping screws on the Feeder back panelMounting and Unmounting the Batch Feeder Mounting the Batch Feeder5. The Feeder window opens Click on the Mount button Click on the Continue buttonPage 11. Turn on the scanner by pressing its on/off switch Click on Done to close the Mount feeder windowUnmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Scanning with the Batch Feeder Batch Scanning with 3fPage Page Custom Setups and Single Scans Page Page Troubleshooting Adjusting the Feeder Angle Aligning the FeederFigure 6 Adjusting the Feeder angle Adjusting the Loading Position Figure 7 Bolts for adjusting the feeder angleNOTE! Do not touch similar looking nuts to the left Figure 8 Unlocking/locking the Feeder positionYou have already loosened the nut, so just click on Continue Figure 9 Using the adjustment tool Figure 10 Adjusting the Feeder position10. Re-mount the Feeder on your scanner and then turn on the scanner 13. You now return to the Feeder window Click on Done to close the Feeder windowShipping the Feeder Preparing the Feeder for Storage or ShippingStoring the Feeder 4. Get the original box and lay down on the floor or on a table Preventive Maintenance DisposalSpecifications Technical InformationCE Declaration