Hasselblad 848 manual Click on Done to close the Feeder window

Page 13

7.Click on Done to close the Feeder window.

13

5.The scanner shuts down and the Mount feeder window updates with new instructions.

If there are original holders in the magazine, then remove them all. They should be very easy to remove—do not use force. When all orig- inal holders have been removed, remove the Feeder itself by lifting it up and away from the scanner. Always store your Feeder by placing it into its original box (see also “Preparing the Feeder for Storage or Shipping” on page 31).

6.Click on Done to close the Mount feeder window. You now return to the Feeder window.

7.Click on Done to close the Feeder window.

8.If you now want to scan using the standard light table, open the light table and switch on the scanner by pressing its on/off switch.

Image 13

Contents User’s Guide by HasselbladBatch Feeder for Flextight 848 and 949 Scanners Page Table of Contents Important Warnings and Restrictions IntroductionGeneral When Operating the Feeder System RequirementsFor All Users For Macintosh UsersA C D E Batch Feeder DiagramB F G H Figure 2 Location of the shipping screws on the Feeder back panel Preparing the Feeder for First Use or after ShippingMounting the Batch Feeder Mounting and Unmounting the Batch FeederClick on the Continue button 5. The Feeder window opens Click on the Mount buttonPage Click on Done to close the Mount feeder window 11. Turn on the scanner by pressing its on/off switchUnmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Batch Scanning with 3f Scanning with the Batch FeederPage Page Custom Setups and Single Scans Page Page Troubleshooting Aligning the Feeder Adjusting the Feeder AngleFigure 6 Adjusting the Feeder angle Figure 7 Bolts for adjusting the feeder angle Adjusting the Loading PositionFigure 8 Unlocking/locking the Feeder position NOTE! Do not touch similar looking nuts to the leftYou have already loosened the nut, so just click on Continue Figure 10 Adjusting the Feeder position Figure 9 Using the adjustment tool10. Re-mount the Feeder on your scanner and then turn on the scanner Click on Done to close the Feeder window 13. You now return to the Feeder windowStoring the Feeder Preparing the Feeder for Storage or ShippingShipping the Feeder 4. Get the original box and lay down on the floor or on a table Disposal Preventive MaintenanceTechnical Information SpecificationsCE Declaration