Hasselblad 848 manual Get the original box and lay down on the floor or on a table

Page 32

4.Get the original box and lay down on the floor or on a table.

32

3.Examine the bottom of the back side of the Feeder and locate the two holes used to secure the magazine during shipping (see Figure 11, below). Insert the shipping screws into these holes and tighten them into place so that the magazine is secured.

4.Get the original box and lay down on the floor or on a table.

5.Open the box, remove the top slab of foam and set it aside.

6.Align the Feeder so that it will fit into the cut foam.

7.Lower the Feeder into the box.

8.Replace the top slab and close the box.

9.Use packaging tape to secure the top flaps of the box. We recommend that you also wrap the box in strong shipping paper.

Figure 11: Holes for inserting the shipping screws on the back of the Feeder

If you need to return the Feeder to Hasselblad for repair, it must be shipped in its original box. Hasselblad will not accept shipment if the Feeder is shipped in anything other than its original box.

Image 32

Contents Batch Feeder for Flextight 848 and 949 Scanners by HasselbladUser’s Guide Page Table of Contents General IntroductionImportant Warnings and Restrictions System Requirements When Operating the FeederFor All Users For Macintosh UsersB F G H Batch Feeder DiagramA C D E Preparing the Feeder for First Use or after Shipping Figure 2 Location of the shipping screws on the Feeder back panelMounting and Unmounting the Batch Feeder Mounting the Batch Feeder5. The Feeder window opens Click on the Mount button Click on the Continue buttonPage 11. Turn on the scanner by pressing its on/off switch Click on Done to close the Mount feeder windowUnmounting the Batch Feeder 7. Click on Done to close the Feeder window Loading Originals into the Feeder Page Scanning with the Batch Feeder Batch Scanning with 3fPage Page Custom Setups and Single Scans Page Page Troubleshooting Adjusting the Feeder Angle Aligning the FeederFigure 6 Adjusting the Feeder angle Adjusting the Loading Position Figure 7 Bolts for adjusting the feeder angleNOTE! Do not touch similar looking nuts to the left Figure 8 Unlocking/locking the Feeder positionYou have already loosened the nut, so just click on Continue Figure 9 Using the adjustment tool Figure 10 Adjusting the Feeder position10. Re-mount the Feeder on your scanner and then turn on the scanner 13. You now return to the Feeder window Click on Done to close the Feeder windowShipping the Feeder Preparing the Feeder for Storage or ShippingStoring the Feeder 4. Get the original box and lay down on the floor or on a table Preventive Maintenance DisposalSpecifications Technical InformationCE Declaration