Sharp AL-1451 operation manual Power to Copier

Page 17

LOADING COPY PAPER

6	Gently push the paper tray back into the copier.
6

After loading copy paper, to cancel the blinking “P” without restarting copying,

press the clear () key. The “P” in the display will go out and the ready () indicator will light up.

2

Installation

POWER TO COPIER

	1	Ensure that the power switch of the copier is in the OFF position. Insert the attached
	1	power cord into the power cord socket at the rear of the copier.

If you use the copier in a country other than the country where the copier was purchased, you will need to make sure that your local power supply is compatible with your model. If you plug the copier into an incompatible power supply, irreparable damage to the copier will result.

2	Plug the other end of the power cord into the nearest outlet.
2

Only insert the power cord into a properly grounded wall socket.

Do not use extension cords or power strips.

15

Image 17

Contents AL-1451 Or 1-877-SHARP-CC toll free/905-568-7140 in Canada For Your ProtectionContents Appendix Conventions used in this manual Getting StartedIntroduction High-quality digital image Main FeaturesHigh-speed laser copying Substantial copying functions Printer featureScan once/ Print many Environmentally friendly designPart Names Operation Panel Copier Installation InstallationBe sure to allow the required space around Unpacking Checking Packed Components and AccessoriesRemoving Protective Packing Materials Installing the TD Cartridge Loading Copy Paper installing the paper tray Corner hooks Power to Copier Initial settings of operation panel Power onPaper Making CopiesNormal Copying When using the SPFWhen using the original table Stream feeding mode Exposure ADJUSTMENT/PHOTO CopyingREDUCTION/ENLARGEMENT/ZOOM To select a preset copy ratio To select a zoom ratioBypass Feed special paper TWO-SIDED Copying Preheat mode Toner Save ModeAuto power shut-off mode Special FunctionsToner Save Mode OFF Displaying Total Number of CopiesTD Cartridge Replacement Supplies and User MaintenanceTD Cartridge Drum Cartridge ReplacementDrum Cartridge Replacement Original table and original cover User MaintenanceCabinet Transfer charger When copier is not in use Misfeed Removal Copier TROUBLE?Misfeed in the paper feed area Misfeed in the fusing areaMisfeed in the transport area Misfeed in the SPF Roller rotating knob Problem Possible cause Solution See TroubleshootingIndication Cause and remedy See Status IndicatorsAutomatic Exposure Adjustment Appendix SpecificationsSpecifications Proper storage Supply Part Numbers and StorageSupply list Moving Instructions TD Cartridge ReplacementNames IndexPacked components Paper Loading Special Memo Memo For users in the USA Sharp Electronics Corporation