6 COPIER TROUBLE?
This chapter describes misfeed removal and troubleshooting.
MISFEED REMOVAL
When the misfeed ( ) indicator blinks or | blinks in the display, the copier will stop because |
of a misfeed. |
|
If a misfeed occurs when using the SPF, a number may appear in the display after a minus sign. This indicates the number of the originals that must be returned to the document feeder tray after a misfeed. Return the required number of originals. Then this number will disappear when copying is resumed or the clear (
) key is pressed.
When the SPF misfeeds an original sheet, the copier will stop and the SPF misfeed ( ) indicator will blink, while the misfeed ( ) indicator will remain off. For a misfeed of originals in the SPF, see “E Misfeed in the SPF” on page 37.
1 | Open the side cover while pressing the side cover open button. |
| |
|
|
6
Copier trouble?
2 | Check the misfeed location. Remove the misfed paper following the instructions for | ||
each location in the illustration below. | |||
| |||
| If | blinks in the display, proceed to “A Misfeed in the paper feed area”. (p. 34) | |
If paper is misfed here, proceed to “B
Misfeed in the fusing area”. (p. 34)
If the misfed paper is seen from this side, proceed to “C Misfeed in the transport area”. (p. 35)
If paper is misfed here, proceed to “A Misfeed in the paper feed area”. (p. 34)
33