7
Appendix
MOVING INSTRUCTIONS
When moving this copier, follow the procedure below.
When moving this copier, be sure to remove the TD cartridge in advance.
1 | Turn the power switch off and disconnect the power cord. |
| |
|
|
2
Open the side cover while pressing the side cover open button. 
Push gently on both sides of the front cover to open the cover.
3Gently pull the TD cartridge out while pressing the lock release button. See page 28,
TD CARTRIDGE REPLACEMENT.
4Close the front cover and then the side cover by pressing the round projections near the side cover open buttton.
When closing the covers, be sure to close the front cover securely and then close the side cover. If the covers are closed in the wrong order, the covers may be damaged.
|
| 5 | Raise the handle of the paper tray and pull the paper tray out until it stops. | |
|
|
|
| |
|
|
| Push the center of the pressure plate down until it locks in place and lock the plate | |
|
| 6 | ||
|
| using the pressure plate lock which has been stored in the front of the paper tray. | ||
|
|
| ||
|
|
| Use a coin (or suitable object) to attach to the left side of the copier the screw that has | |
|
| 7 | ||
|
| been stored in the front of the paper tray. | ||
|
|
|
|
|
|
|
| When shipping the copier, the screw must be reinstalled to prevent shipping |
|
|
|
|
| |
|
|
| damage. |
|
|
|
|
|
|
|
|
|
|
|
|
|
| Push the paper tray back into the copier. | |
|
| 8 | ||
|
|
|
| |
|
|
| Close the paper output tray extension, and attach the packing materials and tape | |
|
| 9 | ||
|
| which were removed during installation of the copier. See page 11, REMOVING | ||
|
|
| PROTECTIVE PACKING MATERIALS. | |
|
|
| Pack the copier into the carton. See page 10, CHECKING PACKED COMPONENTS | |
|
| 10 | ||
|
| AND ACCESSORIES. | ||
|
|
| ||
44