3
Making copies
NORMAL COPYING
This copier has two document input stations - a single pass feeder (SPF) for automatic document feeding and an original table for manual handling of documents. The SPF is designed to hold up to 30 originals measuring from
1 | Ensure that paper of the desired size is set in the paper tray. See page 13, LOADING | |
COPY PAPER. When copying onto paper larger than | ||
| ||
| paper output tray extension. |
2 | Turn the power switch on. | |
| ||
3 | Place the original(s) face up in the document feeder tray or face down on the original | |
table. | ||
|
A. When using the SPF:
(1)Make sure that no original is left on the original table.
(2)Adjust the original guides to the size of originals.
(3)Set the originals face up in the document feeder tray.
●Before feeding originals in the document feeder tray, be sure to remove any staples or paper clips from them.
●Before placing curled or wavy originals into the document feeding tray, be
sure to flatten them. If not, original misfeeds may result.
●The SPF (
) indicator on the operation panel will light up. If this indicator
does not light up, the originals are not properly set or the SPF is not properly closed.
●Badly damaged originals may misfeed in the SPF. It is recommended that such originals be copied from the original table.
●Special originals such as transparency film should not be fed through the SPF, but should be placed directly on the original table.
Original face up
18