5 SUPPLIES AND USER MAINTENANCE
This chapter describes how to replace the TD cartridge and the drum cartridge.
Be sure to use only genuine SHARP parts and supplies.
TD CARTRIDGE REPLACEMENT
The TD cartridge replacement required ( ) indicator will light up when toner is needed. For more information on purchasing the TD cartridge, see SUPPLY PART NUMBERS AND STORAGE on page 43. If copying is continued while theindicator is lit, copies will gradually become lighter until the copier stops and the indicator begins blinking. Replace the old TD cartridge by following the procedure given below.
●After the copier stops, it may be possible to make a few more copies by
taking the TD cartridge out of the copier, shaking it horizontally, then reinstalling it. If copying is not possible after this operation, replace the TD cartridge.
●During long copy run of a dark original, the ready () indicator may blink, theindicator light up, and the copier stop, even though toner is left. The
copier will feed toner up to 2 minutes and then the ready () indicator will
light up. Press the print () key to restart copying.
1 | Open the side cover while pressing the side cover open button. | |
Then, push gently on both sides of the front cover to open the cover. | ||
|
2 | Gently pull the TD cartridge out while pressing the lock release button. Dispose of the | |
old TD cartridge in accordance with local regulations. | ||
| ||
| Lock release button |
5
Supplies and user maintenance
27