Using the SPF/RSPF
The SPF/RSPF is designed to hold up to 30 originals measuring from
•Before feeding originals in the original feeder tray, be sure to remove
any staples or paper clips from them.
• Before placing curled or wavy originals into the original feeder tray, be sure to flatten them. If not, original misfeeds may result.
•The SPF/RSPF ( 
) indicator on the operation panel will light up. If this indicator does not light up, the originals are not properly set or the SPF/RSPF is not properly closed.
•Badly damaged originals may misfeed in the SPF/RSPF. It is recommended that such originals be copied from the original table.
•Special originals such as transparency film should not be fed through the SPF/RSPF, but should be placed directly on the original table.
•Image loss (max. 5/32" (4mm)) can occur at the leading and trailing edges of the copies. Also image loss (max. 11/64" (4.5mm) in total) can occur along the other edges of the copies. It can be 15/64" (6mm) (max.) at the trailing edge of the second copy of
•To stop continuous copying using the SPF/RSPF, press the clear (
) key.
•Copying using
1
2
3
Make sure that no original is left on the original table.
Adjust the original guides to the size of originals.
Set the originals face up in the | Original face up | |
original feeder tray. | ||
|
Stream feeding mode
The stream feeding mode allows easy operation of continuous copying from the SPF/RSPF. If the stream feeding mode has been enabled using user program No.4, the SPF/RSPF ( 
) indicator will blink approximately 5 seconds after the last original has been fed by the SPF/RSPF. While this indicator is blinking, any new originals placed in the original feeder tray will be fed and copied automatically. If the
stream feeding mode has been disabled, the start ( 
) key must be pressed each time the originals are set even immediately after completion of a copy run from the SPF/RSPF. The default setting of the stream feeding mode is "ON". See "USER PROGRAMS" (p.55).
48