| ♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠ | ||
♠ |
| ♠ | |
| ♠ | ||
♠ | For users in the USA |
| ♠ |
♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠ |
| ||
the following measures: |
| ♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠ | |
| This device complies with Part 15 of the FCC rules. Operation is subject to the |
|
|
| following two conditions: (1) This device may not cause harmful interference, |
|
|
| and (2) this device must accept any interference received, including interference |
|
|
| that may cause undesired operation. |
|
|
| WARNING: |
|
|
| FCC Regulations state that any unauthorized changes or modifications to this |
|
|
| equipment not expressly approved by the manufacturer could void the user’s |
|
|
| authority to operate this equipment. |
|
|
| Note: |
|
|
| This equipment has been tested and found to comply with the limits for a Class |
|
|
| B digital device, pursuant to Part 15 of the FCC Rules. These limits are |
|
|
| designed to provide reasonable protection against harmful interference in a |
|
|
| residential installation. This equipment generates, uses and can radiate radio |
|
|
| frequency energy and, if not installed and used in accordance with the |
|
|
| instructions, may cause harmful interference to radio communications. |
|
|
| However, there is no guarantee that interference will not occur in a particular |
|
|
| installation. If this equipment does cause harmful interference to radio or |
|
|
| television reception, which can be determined by turning the equipment off and |
|
|
| on, the user is encouraged to try to correct the interference by one or more of |
|
|
| ● Reorient or relocate the receiving antenna. |
|
|
| ● Increase the separation between the equipment and receiver. |
|
|
| ● Connect the equipment into an outlet on a circuit different from that to which |
|
|
| the receiver is connected. |
|
|
♠ | ● Consult the dealer or an experienced radio/TV technician for help. |
|
|
|
| ♠ | |
♠ |
| ||
| ♠ | ||
| ♠ | ♠ | |
| ♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠ |
| |
Shielded cables must be used with this equipment to maintain compliance with FCC regulations.
Notice for Users in U.S.A.
Installed Printer Board (For Printer Standard Model)
Declaration of Conformity
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Model Number: AL- 12PK (Printer/Scanner Expansion Kit)
Responsible Party: SHARP ELECTRONICS CORPORATION
Sharp Plaza, Mahwah, New Jersey
TEL: 1-800-BE-SHARP
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
This product utilizes
Disposal of these materials may be regulated due to environmental considerations.
For disposal or recycling information, please contact your local authorities or the Electronics Industries Alliance: www.eia.org