Sharp AL-1255, AL-1555, AL-1456, AL-1045 operation manual Selecting the tray, How to select the tray

A:When copying in a one-sided to two-sided mode:

Use the original to copy key to select the desired one-sided to two-sided copying mode (Turn on Long Edge or Turn on Short Edge). See the illustrations on page 52.

B:When copying in the two-sided to two-sided mode:

Use the original to copy key to select the two-sided to two-sided copying mode. The originals must be set in the RSPF before this mode can be set (step 3) on page 48.

C:When copying in the two-sided to one-sided mode:

Use the original to copy key to select the two-sided to one-sided copying mode. The originals must have been set in the RSPF in step 3 on page 48.

A B C

3 Select the copy settings. See "SET THE COPY QUANTITY" (p.49), "EXPOSURE ADJUSTMENT/PHOTO COPYING" (p.49), and "REDUCTION/ENLARGEMENT/ZOOM" (p.51).

Using the original table

If you are using the original table, copying is only possible in one sided to two-sided mode ("A" above).

1	Press the start ( ) key.
2	The original is scanned into the unit's memory.
	Place the original that you wish to copy onto the rear side of the
	paper, and press the start (	) key again.
	Copying begins.	6
Using the RSPF

Press the start ( ) key. Copying begins in the selected two-sided copy mode.

Selecting the tray

How to select the tray

Each time you press the tray select () key, the location indicated by the paper feed location indicator changes in the following order: paper tray 1, paper tray 2, multi-bypass tray.

AL-1555

141 A5 A4

86 A4 B5

70 A4 A5

53