MISFEED REMOVAL
When the misfeed ( 
) indicator blinks or 
blinks in the display, the unit will stop because of a misfeed. If a misfeed occurs when using the SPF/RSPF, a number may appear in the display after a minus sign. This indicates the number of the originals that must be returned to the original feeder tray after a misfeed. Return the required number of originals. Then this number will disappear when copying is resumed or the clear (
) key is pressed. When the SPF/RSPF misfeeds an original sheet, the unit will stop and the SPF/RSPF misfeed ( 
) indicator will blink, while the misfeed (
) indicator will remain off. For a misfeed of originals in the SPF/ RSPF, see "E: Misfeed in the SPF/RSPF" (p.66).
If the unit is turned on with the lower side cover open, the misfeed (
) indicator will blink. In this case, close the lower side cover. The misfeed (
) indicator will go out.
1Open the
To open the
(p.10).
2Check the misfeed location. Remove the misfed paper following the instructions for each location in the illustration
below. If 
blinks in the display, proceed to "A: Misfeed in the paper feed area" (p.64).
If the misfed paper is seen from this side, proceed to "C: Misfeed in the transport area". (p.65)
If paper is misfed here, proceed to "B: Misfeed in the fusing area". (p.64)
If paper is misfed here, proceed to "D: Misfeed in the lower
paper feed area". (p.66)
8
If paper is misfed here, proceed to "A:
Misfeed in the paper feed area". (p.64)
63