Sharp PN-A601 Mounting Precautions, Do not place the monitor on a device which generates heat

MOUNTING PRECAUTIONS

•This product is for use indoors.

•A mounting bracket compliant with VESA specifications is required.

•Since the monitor is heavy, consult your dealer before installing, removing or moving the monitor.

•Mounting the monitor on the wall requires special expertise and the work must be performed by an authorized SHARP dealer. You should never attempt to perform any of this work yourself. Our company will bear no responsibility

for accidents or injuries caused by improper mounting or mishandling.

•Use the monitor perpendicular to a level surface. If necessary, the monitor may be tilted up to 20 degrees upward or downward.

•When mounting the monitor horizontally, the optional fan cover (PN-ZR31) is required. For details along with the horizontal mounting conditions, consult your dealer.

•This monitor should be used at an ambient temperature between 32°F (0°C) and 104°F (40°C). Provide enough space around the monitor to prevent heat from accumulating inside.

•Adhere to the following when installing the monitor in its portrait orientation. Failing to adhere to the following may cause malfunctions.

-Install the monitor such that the power LED is located on the bottom side.

-Set the MONITOR on the SETUP menu to PORTRAIT.

(See page 23.)

-Be sure to secure the power cord (supplied) to the cable clamp attachment with the supplied cable clamp. Make sure that the power cord (supplied) does not supply power to the terminal when being secured and do not over bend the power cord (supplied).

Power cord (Supplied)

Cable clamp attachment

Cable clamp

For the monitor in landscape orientation

	7-7/8 [20]
2	2
[5]	[5]
	2 [5]

For the monitor in portrait orientation

	7-7/8
	[20]
2	2
[5]	[5]
	2 [5]

Unit: inch [cm] 1-3/8 [3.5]

Unit: inch [cm]

1-3/4 [4.5]

•Use the supplied vertical sticker when you install the monitor in portrait orientation.

Operation panel Logo

-Do not remove the factory-affixed sticker but affix the logo sticker over it. Be careful not to cover the remote control sensor or buttons.

•If it is difficult to provide sufficient space for any reason such as the installation of the monitor inside a housing, or if the ambient temperature may be outside of the range of 32°F (0°C) to 104°F (40°C), install a fan or take other measures to keep the ambient temperature within the required range.

•Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP. In such cases, please check the temperature condition specified by the optional equipments.

•Do not block any ventilation openings. If the temperature inside the monitor rises, this could lead to a malfunction.

•Do not place the monitor on a device which generates heat.

E8