TANDBERG D1320202 manual VideoPortal, Mode On/Off or System 1 . IP Address IPAddr

Page 20

TANDBERG GW

Data port Command Interface User Guide

VideoPortal

Registers the 3G Gateway with the VideoPortal

NOTE! The GW needs to reboot before the changes will take effect.

Mode <On/Off> or

System [1 .. 2] IP Address <IPAddr>

---

sub-commands:

•Mode: If Mode = On the 3G Gateway is registered with 1 or 2 video portals

•Address: IP address of the Video Portal the 3G Gateway is to be registered to.

Example of VideoPortal feedback:

*c xConfiguration VideoPortal Mode: On

*c xConfiguration VideoPortal System 1 Address: "10.31.1.8"

*c xConfiguration VideoPortal System 2 Address: "127.0.0.1"

20

Image 20

Contents Tandberg 3G GW D1320202Table of Contents Introduction Tandberg GW Hardware and CablingTroubleshooting Connecting to the Data port Command Interface using Telnet Command format Command typesIntroduction Xconf H323Gatekeeper ?Xconf telnet mode CommandsXconf telnet mode on System Configuration Commands Command Description H323GatekeeperH323CallSetup H323CallSetup Mode Direct/GatekeeperIsdn EthernetEthernet speed Snmp HttpsHttp SSH TelnetTandberg GW General GW Commands Command Description GatewayNTP SIP Tandberg GW Example of SS7 feedback Tandberg GW Mode On/Off or System 1 . IP Address IPAddr VideoPortalSystem Status Commands TemperatureCelciusTemperatureFahrenheit PRIDNS URL Status Address PortAddress Protocol BRI PRIFeedback 1 FeedbackGatewayCall StatusStatus Address Port Last Update Last Correction SystemLoadSystemLoad Call 1 CallDebug Commands Special CommandsError Result parameters ParametersExpression 1 . S 0, 256 XPath expression OK Result parametersServiceEntryDelete Parameters ServiceEntryNumberr Example Delete Service nrServiceEntrySwap OptionKeyDeleteXhistory ? ExamplesXhistory Tandberg GW Index Commands