TANDBERG D1320202 manual Introduction

Page 3

TANDBERG GW

Data port Command Interface User Guide

1.Introduction

The TANDBERG GW Data port Command Interface User Guide contains guidelines on how to use the textual command interface supported by the GW. The Data port Command Interface can be accessed through Telnet via the LAN interface or through RS-232 by connecting a serial cable to the serial interface connector, referred to as the Data port (ref. chapter 2). Three Telnet sessions can be connected to the GW at the same time in addition to the RS-232 connection.

If, after reading this manual, you require additional information concerning the use of the TANDBERG GW Data port Command Interface, please contact your local TANDBERG dealer who will be able to supply you with relevant information for special applications.

Image 3

Contents D1320202 Tandberg 3G GWTable of Contents Introduction Hardware and Cabling Tandberg GWTroubleshooting Connecting to the Data port Command Interface using Telnet Xconf H323Gatekeeper ? Command formatCommand types IntroductionCommands Xconf telnet mode onXconf telnet mode H323CallSetup Mode Direct/Gatekeeper System Configuration CommandsCommand Description H323Gatekeeper H323CallSetupEthernet Ethernet speedIsdn Https HttpSnmp Telnet SSHTandberg GW Command Description Gateway General GW CommandsNTP SIP Tandberg GW Example of SS7 feedback Tandberg GW VideoPortal Mode On/Off or System 1 . IP Address IPAddrPRI System Status CommandsTemperatureCelcius TemperatureFahrenheitDNS Status Address Port Address ProtocolURL PRI BRIStatus Feedback 1Feedback GatewayCallCall Status Address Port Last Update Last CorrectionSystemLoad SystemLoad Call 1Special Commands Debug CommandsOK Result parameters Error Result parametersParameters Expression 1 . S 0, 256 XPath expressionOptionKeyDelete ServiceEntryDeleteParameters ServiceEntryNumberr Example Delete Service nr ServiceEntrySwapExamples XhistoryXhistory ? Tandberg GW Index Commands