TANDBERG D1320202 manual Connecting to the Data port Command Interface using Telnet

Page 6

TANDBERG GW

Data port Command Interface User Guide

3.Connecting to the Data port Command Interface using Telnet

The TANDBERG 3GW has one LAN port.

The GW’s Telnet server provides access to the Data port Command Interface through a 10/100 base T network interface supporting the TCP/IP protocol.

When connected to the 3G Gateway, type tsh to start a t-shell from the command line. The Telnet client will receive a welcome message similar to the following:

Welcome to TANDBERG

TANDBERG 3G Gateway Release R2.0 customer

SW Release Date: 2006-03-28

NOTE! If the TANDBERG 3GW is protected by an IP password you will be prompted to enter this password before you can access the Data port Command Interface via Telnet.

6

Image 6
Contents Tandberg 3G GW D1320202Table of Contents Introduction Tandberg GW Hardware and CablingTroubleshooting Connecting to the Data port Command Interface using Telnet Introduction Command formatCommand types Xconf H323Gatekeeper ?Commands Xconf telnet mode onXconf telnet mode H323CallSetup System Configuration CommandsCommand Description H323Gatekeeper H323CallSetup Mode Direct/GatekeeperEthernet Ethernet speedIsdn Https HttpSnmp SSH TelnetTandberg GW General GW Commands Command Description GatewayNTP SIP Tandberg GW Example of SS7 feedback Tandberg GW Mode On/Off or System 1 . IP Address IPAddr VideoPortalTemperatureFahrenheit System Status CommandsTemperatureCelcius PRIDNS Status Address Port Address ProtocolURL BRI PRIGatewayCall Feedback 1Feedback StatusSystemLoad Call 1 Status Address Port Last Update Last CorrectionSystemLoad CallDebug Commands Special CommandsExpression 1 . S 0, 256 XPath expression Error Result parametersParameters OK Result parametersServiceEntrySwap ServiceEntryDeleteParameters ServiceEntryNumberr Example Delete Service nr OptionKeyDeleteExamples XhistoryXhistory ? Tandberg GW Index Commands