TANDBERG D1320202 manual General GW Commands, Command Description Gateway

Page 14

TANDBERG GWData port Command Interface User Guide

4.2.2. General GW Commands

Command:

Description:

Gateway

This command is used to configure the 3G gateway dialling rules, like for

 

example direct inward dialling, H323 call prefixes and dial in numbers. It is

 

possible to define 100 services, each with the parameters:

 

Description indicates the user applied name of the service

 

InNetType indicates the dial in for this particular service

 

configuration.

 

OutNetType indicates the dial out for this particular service

 

configuration

 

InPrefix will be used for matching the incoming called

 

number/address and is used to register with the gatekeeper in case

 

call type is H323

 

InPostfix is the part of the dialed number that will be

 

removed/replaced.

 

ServiceType indicates whether this service is a direct inward dialing,

 

a phonebook or an IVR service is.

 

OutPrefix and OutPostfix will be used to construct the

 

number/address that will be called (if applicable) using this service.

Service [1..100] Description: <S: 0, 30> or

Service [1..100] InNetType: <H324m/3G/H323 > or

Service [1..100] OutNetType: <H324m/3G/H323 > or

Service [1.. 100] InPrefix: <S: 0, 30> or

Service [1.. 100] InPostfix: <S: 0, 30> or

Service [1.. 100] ServiceType: < None/DiD/IVR/Phonebook > or

Service [1.. 100] OutPrefix: <S: 0, 30> or

Service [1.. 100] OutPostfix: <S: 0, 30> or

LoadLimit: <0..100>

---

Parameters:

sub-commands:

Description: This is a friendly name for the service configured like for example 3G to H323 and 3G hotline to H323

InNetType.

OutNetType

InPrefix.

InPostfix

ServiceType

OutPrefix

OutPostfix

LoadLimit The GW will signal busy to the gatekeeper when the current load on the GW reaches this limit. The current system load can be monitored by the status command SystemLoad

14

Image 14
Contents Tandberg 3G GW D1320202Table of Contents Introduction Tandberg GW Hardware and CablingTroubleshooting Connecting to the Data port Command Interface using Telnet Introduction Command formatCommand types Xconf H323Gatekeeper ?Xconf telnet mode CommandsXconf telnet mode on H323CallSetup System Configuration CommandsCommand Description H323Gatekeeper H323CallSetup Mode Direct/GatekeeperIsdn EthernetEthernet speed Snmp HttpsHttp SSH TelnetTandberg GW General GW Commands Command Description GatewayNTP SIP Tandberg GW Example of SS7 feedback Tandberg GW Mode On/Off or System 1 . IP Address IPAddr VideoPortalTemperatureFahrenheit System Status CommandsTemperatureCelcius PRIDNS URL Status Address PortAddress Protocol BRI PRIGatewayCall Feedback 1Feedback StatusSystemLoad Call 1 Status Address Port Last Update Last CorrectionSystemLoad CallDebug Commands Special CommandsExpression 1 . S 0, 256 XPath expression Error Result parametersParameters OK Result parametersServiceEntrySwap ServiceEntryDeleteParameters ServiceEntryNumberr Example Delete Service nr OptionKeyDeleteXhistory ? ExamplesXhistory Tandberg GW Index Commands