TANDBERG D1320202 manual Commands, Xconf telnet mode on

Page 8

TANDBERG GW

Data port Command Interface User Guide

User Commands, Xcom.

Parameter Configuration Commands are commands that set a system parameter to a specific value. E.g.: The command Xconf telnet mode: "on" enables telnet access on the gateway. If the command is syntactically correct the GW returns OK, otherwise the GW returns ERROR. When the parameter is successfully changed, the GW will return the command with the new value. An example is shown below (the user input is shown in bold).

Xconf telnet mode: "on"

OK

*c xConfiguration Telnet Mode: On

When issuing a Parameter Setting Command without a parameter, the GW will return the command with the current setting. E.g.:

Xconf telnet mode

*c xConfiguration Telnet Mode: On

OK

Status Commands are commands that list different sets of system parameters. Status commands are automatically called when corresponding parameters are being changed.

4.2.The commands

The commands are divided into five groups: System Configuration Commands, General GW Commands, System Status Commands, Debug Commands and Special Commands.

8

Image 8
Contents Tandberg 3G GW D1320202Table of Contents Introduction Tandberg GW Hardware and CablingTroubleshooting Connecting to the Data port Command Interface using Telnet Command format Command typesIntroduction Xconf H323Gatekeeper ?Xconf telnet mode CommandsXconf telnet mode on System Configuration Commands Command Description H323GatekeeperH323CallSetup H323CallSetup Mode Direct/GatekeeperIsdn EthernetEthernet speed Snmp HttpsHttp SSH TelnetTandberg GW General GW Commands Command Description GatewayNTP SIP Tandberg GW Example of SS7 feedback Tandberg GW Mode On/Off or System 1 . IP Address IPAddr VideoPortalSystem Status Commands TemperatureCelciusTemperatureFahrenheit PRIDNS URL Status Address PortAddress Protocol BRI PRIFeedback 1 FeedbackGatewayCall StatusStatus Address Port Last Update Last Correction SystemLoadSystemLoad Call 1 CallDebug Commands Special CommandsError Result parameters ParametersExpression 1 . S 0, 256 XPath expression OK Result parametersServiceEntryDelete Parameters ServiceEntryNumberr Example Delete Service nrServiceEntrySwap OptionKeyDeleteXhistory ? ExamplesXhistory Tandberg GW Index Commands