TANDBERG T1 manual Administrator Guide

Page 46

T1

Contents

Introduction

Getting started

Sharing a PC presentation

General recommendations for high end team collaboration rooms, team meeting rooms and showroom floor are described on the previous page.

Dual video stream

With dual video stream you can view two different live video streams simultaneously, the main video and one additional source. This could for example be both a PC presentation and the person who gives the presentation.

If one of the video systems does not support Dual Video Stream, no second video stream will be established and the PC presentation will be shown as the main video.

Sharing the presentation

1.Make sure the PC do not cover any of the microphones as this will reduce the audio quality at the far end

2.Locate the DVI cable and connect the PC to the video system

3.When pressing the PC button () on the remote control the default presentation source is activated.

The DVI/VGA input is compliant with VESA Extended Display Identification Data (EDID) and will be able to notify the PC of the supported output formats.

Troubleshooting if the presentation does not show

Administrator Guide

About the menus

About the settings

Settings Library

Cameras

 

AppenAppendicesi

Contact us

 

 

 

 

 

 

 

Shows the PC presentation and the participants

PC

On most PC’s you must press a special key combination to switch the PC image from the PC screen to the video screen

Make sure the connector used for PC presentation is configured as the default presentation source.

Go to: Home > Administrator settings > Advanced configurations > Video > DefaultPresentationSource (the default value is 3, and corresponds to ...Video > Input > Source 3)

Make sure your PC is set to activate your VGA output

Other presentation sources

You can also connect other presentation sources like:

DVD

Document camera

The screen layout

Press the Layout button on the remote control to select a suitable layout on screen.

The default layout when showing a PC presentation is designed to allow the participants to keep eye contact with each other during the presentation.

Default layout with a wide signal in from the PC (currently only supported on digital input)

Default layout with a 4/3 signal in from the PC.

D14274.01—NOVEMBER 2008

46

Image 46
Contents Tandberg T1 NovemberTable of Contents What’s in this guide?Chapter IntroductionThis chapter Tandberg T1 at a glance Disclaimer Intellectual Property RightsTrademark Patent InformationSafety Instructions Water and MoistureEnvironmental Issues TANDBERG’s Environmental PolicyGetting started System overview Cable configurations LANUsing the Remote Control BatteriesUsing the Remote Control, Call KEYTurn on the system Verify IP address settingsIf you need to set a static IP address Time zone settings Verify your settingsAdd the system to the network About the menus About the menus Settings The Settings menuAdministrator settings menu Home The Home menuSettings menu Explaining the administrator settingsAdministrator settings IP Settings menuAdvanced configuration menu SearchAdministrator Settings Library SIPAdvanced configuration menu Audio settingsAudio Input Line 1. Level Audio Output Hdmi 1, 3 Mode On/OffAudio Output Line 1. Mode On/Off Audio Input Line 1. Channel Left/Right/MonoCamera settings Conference settings Do not disturb setting Network settings Network services settings NetworkServices Snmp SystemContact S 0 NetworkServices Snmp Mode Off/ReadOnly/ReadWriteNetworkServices Snmp CommunityName S 0 NetworkServices Snmp SystemLocation S 0Provisioning settings Phone book server settingsSerial port settings SIP Profile settings Standby settingsSystem unit settings Time zone settingVideo Input Source 1. CameraControl Mode On/Off Video OSD Mode On/OffVideo Input Source 2 Connector HDMI/HDSDI/YPbPr Video Input Source 1 Connector HDMI/HDSDI/YPbPrExample Video Output DVI 2 Resolution Video Output Composite 5 Resolution PAL/NTSCExample Video Output Hdmi 1 Resolution Example Video Output Composite 5 Resolution NtscCameras Kensington lock PrecisionHD 1080p cameraHdmi and HD-SDI Cascaded camerasConnecting the camera Tandberg T1Best view-Face recognition Using Best viewTandberg TRC5 Video output formats DIP switch settings for video output formatsLine voltage frequency Cameras in daisy chain Appendices Tandberg DnamRoom equipment General room guidelinesPhysical conditions Environmental considerationsBest audio quality to all participants Audio qualityNatural communication Making eye contactGeneral recommendations for the room layout Guidelines for the telepresence room setupAdjust the camera view Distance between the table and the video systemSharing a PC presentation Shows the PC presentation and the participantsGuidelines for the high end meeting room setup Camera viewAdministrator Guide Tandberg Remote Control TRC5 ArrowsAPI commands Configure the video inputsAdministrator settings Video Input MatrixSoftware upgrade Software upgrade procedureHow to upload the certificate Certificates upload procedureUpload certificates XML files ConfigurationCommand View XML filesLog files Debug log filesDnam Loudspeaker Cabinet Dnam AmplifierNTP Time Zone expressions NTP Time Zone expressions, NZ-CHAT GMT+0GMT0 CETCurrent RFCs and drafts supported in SIP Supported RFCs in SIPMedia capabilities supported in SIP CE Declaration for Telepresence T1 China RoHS table Left side view Tandberg T1 dimensionsFront view Top viewPrecisionHD 1080p camera dimensions Unit Delivered Complete with Technical specificationsPAL/NTSC Gpio TCP/IP DhcpHTTP, Https Headquarters European Headquarters Tandberg