TANDBERG T1 manual Dnam Loudspeaker Cabinet, Dnam Amplifier

Page 53

T1

Contents

Introduction

Getting started

About the menus

About the settings

Settings Library

Cameras

Administrator Guide

 

AppenAppendicesi

Contact us

 

 

 

TANDBERG DNAM

The TANDBERG DNAM – Digital Natural Audio Module – is built on two specially designed and separate modules, the amplifier and the loudspeaker cabinet.

The DNAM Loudspeaker Cabinet

3-way Center Speaker system

Frequency range 50Hz - 20kHz

2 x 100mm low- and midrange loudspeakers,

8 ohms nominal, excellent quality (SEAS Excel series)

1 x 25mm dome tweeter, 6 ohms nominal, high quality

Crossover filtered audio signals received from DNAM amplifier

Long time max power 70 Watt on all loudspeakers

Enclosed MDF speaker cabinet

Integrated Stereo Speaker

2-way Stereo Speaker System, each side has:

1 x 100mm low- and midrange loudspeaker, 8 ohms nominal, excellent quality (SEAS Excel series)

1 x 25mm dome tweeter, 6 ohms nominal, high quality

Passive crossover filter

Frequency range 70 Hz - 20 kHz

Long time max power 70 Watt

Enclosed MDF speaker cabinet

DNAM Loudspeaker

 

DNAM Amplifier

15 pin D-SUB

 

 

(for loudspeakers)

RCA (audio in)

 

RCA (loop out)

 

XLR–female

Power socket

 

XLR–male

 

 

Fuses

The DNAM Amplifier

3 x 50W continuous average Center Output Power (load specified by DNAM Center Speakers).

2 x 50W continuous average Stereo Output Power (load specified by TANDBERG Loudspeaker Stereo Kit).

Full dynamic range for audio (high fidelity range) or Integrated stereo speakers.

Digital Signal Processing and Filtering on all channels for best audio detail clarity.

Digital Crossover Filtering on center channels.

In/out:

Audio In - SPDIF (stereo) or Analog (mono), using the same connector.

Differential In - (female XLR pinout: 1 - GND, 2 – Signal (+), 3 – Signal (-))

Loop Out - line out directly from the input, always analog even with SPDIF in.

Stereo Out - (male XLR, common GND configuration)

Fuse 2A 250V Slow, 5 x 20mm, Littelfuse type 215002.

D14274.01—NOVEMBER 2008

53

Image 53
Contents November Tandberg T1What’s in this guide? Table of ContentsThis chapter IntroductionChapter Tandberg T1 at a glance Trademark Intellectual Property RightsDisclaimer Patent InformationWater and Moisture Safety InstructionsTANDBERG’s Environmental Policy Environmental IssuesGetting started System overview LAN Cable configurationsBatteries Using the Remote ControlCall KEY Using the Remote Control,If you need to set a static IP address Verify IP address settingsTurn on the system Add the system to the network Verify your settingsTime zone settings About the menus Administrator settings menu Settings The Settings menuAbout the menus Home The Home menuExplaining the administrator settings Settings menuIP Settings menu Administrator settingsSearch Advanced configuration menuSIP Administrator Settings LibraryAudio settings Advanced configuration menuAudio Output Line 1. Mode On/Off Audio Output Hdmi 1, 3 Mode On/OffAudio Input Line 1. Level Audio Input Line 1. Channel Left/Right/MonoCamera settings Conference settings Do not disturb setting Network settings Network services settings NetworkServices Snmp CommunityName S 0 NetworkServices Snmp Mode Off/ReadOnly/ReadWriteNetworkServices Snmp SystemContact S 0 NetworkServices Snmp SystemLocation S 0Serial port settings Phone book server settingsProvisioning settings Standby settings SIP Profile settingsTime zone setting System unit settingsVideo Input Source 2 Connector HDMI/HDSDI/YPbPr Video OSD Mode On/OffVideo Input Source 1. CameraControl Mode On/Off Video Input Source 1 Connector HDMI/HDSDI/YPbPrExample Video Output Hdmi 1 Resolution Video Output Composite 5 Resolution PAL/NTSCExample Video Output DVI 2 Resolution Example Video Output Composite 5 Resolution NtscCameras Hdmi and HD-SDI PrecisionHD 1080p cameraKensington lock Cascaded camerasTandberg T1 Connecting the cameraTandberg TRC5 Using Best viewBest view-Face recognition Line voltage frequency DIP switch settings for video output formatsVideo output formats Cameras in daisy chain Tandberg Dnam AppendicesPhysical conditions General room guidelinesRoom equipment Environmental considerationsNatural communication Audio qualityBest audio quality to all participants Making eye contactAdjust the camera view Guidelines for the telepresence room setupGeneral recommendations for the room layout Distance between the table and the video systemShows the PC presentation and the participants Sharing a PC presentationCamera view Guidelines for the high end meeting room setupAdministrator Guide Arrows Tandberg Remote Control TRC5Administrator settings Configure the video inputsAPI commands Video Input MatrixSoftware upgrade procedure Software upgradeUpload certificates Certificates upload procedureHow to upload the certificate Command ConfigurationXML files View XML filesDebug log files Log filesDnam Amplifier Dnam Loudspeaker CabinetNTP Time Zone expressions NTP Time Zone expressions, GMT0 GMT+0NZ-CHAT CETMedia capabilities supported in SIP Supported RFCs in SIPCurrent RFCs and drafts supported in SIP CE Declaration for Telepresence T1 China RoHS table Front view Tandberg T1 dimensionsLeft side view Top viewPrecisionHD 1080p camera dimensions PAL/NTSC Technical specificationsUnit Delivered Complete with HTTP, Https TCP/IP DhcpGpio Headquarters European Headquarters Tandberg