Runco VX-60d, VX-40d, VX-50d, VX-80d manual DHD Controller Rear Panel, Outputs

Page 23

Controls and Functions

7.ENTER BUTTON

When an item is highlighted on the On-Screen Display, the ENTER button selects the item.

8.DOWN BUTTON

Use to direct select aspect ratios or move the menu cursor down in the On-Screen Display. When no menu is present on-screen, this button toggles you through the different aspect ratios, in this order:

Virtualwide 2.35 - Cinema - VirtualWide - Letterbox - Standard (4:3) - Anamorphic

9.RIGHT BUTTON

Used to direct select inputs or move the menu cursor right in the On Screen Display. When no menus are present on-screen, the RIGHT button toggles you through the different sources, in this order:

Composite - S-Video 1 - S-Video 2 - Component SD - HD/RGB 1 - HD/RGB 2 - DVI 1 - DVI 2 - HD Pass Thru 1 - HD Pass Thru 2

10.MENU BUTTON

Pressing the MENU button brings up the main menu. Also, if you are in an adjustment mode or function, pressing MENU brings the menu back one level.

Figure 2-5shows the rear connector panel on the DHD Controller.

2.5

DHD Controller Rear Panel

Serial No

Runco International

Union City, CA

Model

OUTPUTS

R/PrG/YB/Pb

Video Processor / Controller

INPUTS

R/Pr	G/Y	B/Pb	H		V
						HD1
						HD2
R/Pr	G/Y	B/Pb	H		V
				SDI	Pb	Pr
					Pb	Pr

4	8			10
		SYSTEM CONTROL INTERFACE
		TRIGGERS
	1	2	3	IR

WARNING: TO REDUCE THE RISK OF FIRE

OR ELECTRIC SHOCK, DO NOT EXPOSE

THIS APPLIANCE TO RAIN OR MOISTURE.

Y	S-Video 1

CAUTION	!
RISK OF ELECTRIC SHOCK
DO NOT OPEN

AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER- SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE CENTER.

100-230VAC 50-60 Hz, 165 Watts Max

H

V

H/V

DVI Out

	DVI 1	DVI 2	Option	Component Video	Video	S-Video 2 RS-232 Out	RS-232 Control

Made In USA

1235 6 7 9 1112 13 14

Figure 2-5. DHD Controller Rear Panel
1. ANALOG OUTPUTS (RGBHV)	Outputs
Connect these to the RGBHV inputs (Input 1) on the VX-40d/-50d/-60d/-80d.

If the DVI 1 or DVI 2 input is active and the input signal is

Note HDCP-encrypted, the RGBHV output of the DHD Controller is disabled.

2.DVI OUT

Connect this to Input 2 (DVI) on the VX-40d/-50d/-60d/-80d.

Runco VX-40d/-50d/-60d/-80d Owner’s Operating Manual

11

Image 23

Contents VX-40d / VX-50d VX-60d / VX-80d Page For Projectors, Video Processors and Controllers TWO Year Limited WarrantyEffective Warranty Date Runco INTERNATIONAL, INC Safety Precautions Table of Contents Install Projector Stand CineWide with AutoScope, Floor-Mount Serial Communications Maintenance and TroubleshootingSpecifications OperationTable of Contents List of Figures Xii About This Manual Degrade performance or cause a malfunction Using This ManualCertain features Significance. They also provide supplemental informationDescription, Features and Benefits Runco Optional AccessoriesVX-40d/-50d/-60d/-80d Top/Rear/Front View VX-40d/-50d/-60d/ -80d at a GlanceVX-40d/-50d/-60d/ -80d Input Panel Rear Foot Stationary Power Input 100 to 240 VACInput 2 DVI RS232RS232 OUT Not used RS422 Not used Gpio Not used Input 3 Video / Input 4 S-VideoVX-40d/-50d/-60d/-80d has its own internal menu system VX-40d/-50d/-60d/ -80d Rear-Panel KeypadFocus ZoomExit Menu Navigation ButtonsInput 1 BNC HelpDHD Controller Front Panel DHD Controller Front PanelOutputs DHD Controller Rear PanelVideo 1 / S-VIDEO HD1 / HD2 Analog BNC connectorsComponent Video RCA connectors Inputs 3. DVI 1 / DVI 2 DigitalDHD Controller Remote ControlVideo On / OFFCursor Buttons For more information about aspect ratios, refer to Table4X3 Standard 43 Memory Preset Buttons ISF NT NightAspect Ratio Selection Buttons ANA AnamorphicControls and Functions Installation Step Procedure For Details, Refer to Quick SetupInstallation Overview Installation specialistAmbient Light Installation ConsiderationsProjector Installation Options Installation TypeMinimum Maximum VX-40d/-50d Lens Options and Throw RatiosThrow Ratio Throw Distance Range Lens Option Note Throw DistLens Option Note Throw Dist Screen Width Minimum Maximum VX-60d/-80d Lens Options and Throw RatiosPosition Vertical and HorizontalScreen center are aligned with each other Horizontal Lens ShiftFolded Optics Lens Assembly Front View Installing the Projection LensFixed CineWide Are both fully assembled Installing the Optional CineWide Lens MountAutoScope or Base Plate AutoScope stand used for floor-mounted projector Ceiling Mounting Adjusting the ProjectionMounting VX-40d/-50d/-60d/ -80d Floor MountingConnecting the DHD Controller to VX-40d/-50d/-60d/-80d Connector Panel AccessConnecting Source 10. Digital DTV RGB or Component Video Connections Digital DTV RGB or Component Video Connections See Figure11. Analog RGB Connections Analog Computer RGB Connections See Figure12. Composite, S-Video and Component Video Connections Composite/S-Video/Component Video Connections See FigureTrigger Outputs to Connecting 12-VoltRS-232 Controller ConnectionInput voltage to the AutoScope lens motor must be between Connecting to AC PowerSelecting the Input Source Turning on the PowerYou must enter a passcode to access the Service menu Focus Zoom Vertical and Horizontal Lens Shift Adjusting the Picture Orientation Primary Lens AdjustmentsWith AutoScope or Base Installing and Adjusting the CineWide Anamorphic LensAssembly to Lens Motor Carriage Plate CineWideHorizontal Position X Adjustment Too Low Correct position Too High Geometry Wrong Position Correct PositionCalibrating Projector Inputs Main TheaterMaster Remote 1. Power Button Control Functions Navigating the Projector Menus Are disabledChannel Setup 17. Copying a Channel You cannot use Auto Setup with a locked channel. Copy Auto SetupNative aspect ratio is with the primary lens only. With an 18. Resize Presets No ResizingInstallation Recommended see below Adjust Pixel Tracking before Pixel PhaseValues shown represent where the approximate center On an internal grayscale test pattern Input Levels are not applicable to DVI InputExperienced technicians use the Input Levels submenu Uncheck this item before exiting this menu There must be at least two consecutive white pixels presentOriginally expected may no longer be possible Working With the LampIntensity value is not the actual lumen output, but rather a More easily maintained as the lamp ages Installation Operation Using the On-Screen MenusAspect Ratio ISF PresetsService Input SourceHD Pass Thru 1 HD Pass Thru Main MenuInput Source Aspect RatioRemote Aspect Ratio Control Description Key Aspect Ratio SettingsPicture Brightness Contrast Color Tint Sharpness PictureTypical Pluge Pattern for Adjusting Brightness Gray Yellow Cyan Green Magenta Red Blue Gray Yellow Cyan Green Magenta Red Blue Input Position Left/Right Up/Down Width Height Overscan ResolutionInput Position Serial Number Hardware Firmware 0002.003A Date Mar 15 ISF PresetsISF Presets ISF Night ISF Day Custom Save Factory Default InformationCalibration You must enter a passcode to access the Calibration menuOperation Input Names Restore Composite Video Component SD ServiceTip Auto ADC Bandwidth Auto YPbPr Input ResolutionHD/RGB 1 and HD/RGB 2 Color Space Select Auto, RGB or YUV Operation Removing the Lamp Door Lamp and Filter ReplacementRemoving the Lamp Lamp is accurate Recording the Serial Number of a New LampRemoving the Primary Lens Lens ReplacementSymptom Possible Causes Solution Troubleshooting TipsTroubleshooting Chart Power down the projector Code Description General VX-40d/-50d/-60d/-80d Error CodesError Codes Code Description Lamp Failures Power and CoolingPanel Driver and Formatter Code Description Tipm Image ProcessorBuilt-In Keypad Code Description Miscellaneous Command RS-232 Connection and Port ConfigurationSerial Command Syntax Serial CommandsVIRTUAL235 YES Aspect Ratio CommandsImage Preset Commands Output Shift Commands Value Description Min/max Stored? Input Position CommandsBkgnd Serial Communications VX-40d/-50d/-60d/-80d Specifications VX-40d/-50d/-60d/ -80d SpecificationsVX-50d/-80d Home Theater Calibration SpecificationsIndustry-Standard Specifications Power Requirements VX-40d/-60dSpecifications are subject to change without notice DimensionsWeight without lens Limited WarrantyDHD Controller Specifications DHD Controller SpecificationsVX-40d/-50d/-60d/-80d Dimensions VX-40d/-50d/-60d/ -80d DimensionsSpecifications Page Runco CL-810 Owner’s Operating Manual