Runco VX-50d, VX-40d, VX-80d, VX-60d Adjusting the Picture Orientation Primary Lens Adjustments

Installation

By default, the VX-40d/-50d/-60d/-80d is configured for a “floor/front” installation, in which the projector is installed upright and in front of the screen. If it is installed behind the screen and/or mounted on a ceiling, you must change the picture orientation. To do this:

1.On the DHD Controller, press MENU and enter the Service Menu passcode.

2.Select Service from the Main Menu.

3.Select Display Device from the Service Menu.

4.Select Configure from the Display Device menu, then select Installation.

5.Choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the installation method.

To access the motorized primary lens controls:

1.On the DHD Controller, press MENU and enter the Service Menu passcode.

2.Select Service from the Main Menu.

3.Select Display Device from the Service Menu.

4.Select Configure from the Display Device menu, then select Lens.

The Lens menu gives you a great deal of control over the picture size, position and focus:

To focus the projected image, use the cursor buttons to highlight “In” or “Out.” Then, press and hold the ENTER button.

To make the picture smaller (zoom out), use the cursor buttons to highlight the minus sign (-). Then, press and hold the ENTER button.

To enlarge the picture (zoom in), use the cursor buttons to highlight the plus sign (+). Then, press and hold the ENTER button.

To change the lens position, use the cursor buttons to highlight “Left,” “Right,” “Up” or “Down” in the Lens menu. Then, press and hold the ENTER button to shift the lens in that direction.

3.10

Adjusting the Picture Orientation

3.11 Primary Lens Adjustments

Focus

Zoom

Vertical and Horizontal Lens Shift

Runco VX-40d/-50d/-60d/-80d Owner’s Operating Manual 37