Runco VX-60d, VX-40d, VX-50d, VX-80d manual You cannot use Auto Setup with a locked channel. Copy

Installation

Use the Auto Setup feature of the VX-40d/-50d/-60d/-80d as a convenient starting point	Auto Setup
for calibrating the projector inputs for optimum picture quality.

You cannot use Auto Setup with a locked channel. Copy the

Note locked, factory-default channel for the current input to a new channel before using Auto Setup; refer to Copying Channels on page 46.

Auto Setup is an automated process in which the projector quickly optimizes critical display parameters such as size, position and pixel tracking, based on the type of incoming video signal. An Auto Setup allows you to quickly get the image “in the ballpark” after which you can perform further calibration, if necessary.

To perform an Auto Setup, do one of the following:

On the Theater Master Remote Control: Press FUNCS, then AUTO followed by

Enter. When the Auto Setup completes, press Enter again to keep the new settings.

On the Projector Rear Keypad: Press AUTO SETUP followed by Enter. When the

Auto Setup completes, press Enter again to keep the new settings.

On the DHD Controller Remote Control: Press MENU, then select Service from the Main menu. Select Display Device from the Service Menu. Finally, select Configure from the Display Device menu, then select Auto Setup.

What an “Auto Setup” Does: Auto Setup sets the following parameters to their default values:

•Contrast

•Brightness

•Auto Input Level (off)

•Detail (if video source)

•Filter

•Luma Delay

Auto Setup also optimizes the following settings, based on the characteristics of the incoming signal:

•Pixel Tracking

•Pixel Phase

•Size and Blanking

•Vertical Stretch

•Position

•Input Levels

If additional fine-tuning is necessary after performing an Auto Setup, continue with the next section.

Runco VX-40d/-50d/-60d/-80d Owner’s Operating Manual 47