Runco VX-60d, VX-40d, VX-50d, VX-80d manual Horizontal Position X Adjustment

Installation

(Skip this step if you are installing a fixed CineWide anamorphic lens.)

CineWide with AutoScope maintains constant image height independent of the aspect ratio, while using the full display resolution of the projector. It accomplishes this by moving the anamorphic lens in front of the primary lens when widescreen material is being viewed. When the viewer transitions back to 16:9 or 4:3 source material, the anamorphic lens moves out of the light path.

To configure the lens motor trigger on the DHD Controller for proper AutoScope operation:

1.Press MENU on the remote control and enter the Service menu passcode.

2.Select Service from the Main menu.

3.Select Triggers from the Service menu.

4.Assign the trigger output to which the lens motor is connected to the Cinema and Virtualwide 2.35 aspect ratios. This enables the lens motor to move the anamorphic lens into position (in front of the primary lens) when either aspect ratio is selected.

5.To save the trigger settings, press repeatedly to highlight “Save.” Then, press

ENTER.

6.Select the Cinema or Virtualwide 2.35 aspect ratio to move the anamorphic lens into position, if it isn’t already. To do this, press CINEMA or SVC on the DHD Controller remote control (Figure 2-6), or press or repeatedly with no menus visible on-screen.

Horizontal Position (X) Adjustment:

1.Project a white field on the screen.

2.Loosen the Yaw/X-Adjustment Levers underneath the lens.

3.Slowly move the anamorphic lens into place so that there are no shadows on either side of the screen:

Too Far Left

Correct position

Too Far Right

4.When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to secure the lens in place.

Configure Lens Motor Trigger (CineWide with AutoScope)

Adjust the Anamorphic Lens

Runco VX-40d/-50d/-60d/-80d Owner’s Operating Manual 39