Runco VX-22I operation manual Attaching the Anamorphic Lens to the Lens Adapter Ring

2.Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate or fixed CineWide Base Plate (item #7). Position the bracket so that the long slot at the bottom of the lens holder is perpendicular to the corresponding slots on the plate.

3.Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers (item #6) and Yaw/X Adjustment Levers that you removed in Step 1.

4.Use the Lens Mounting Screws to attach the Lens Adapter Ring (item #1) to the Pitch Adjustment Yoke (item #2); see Figure 3-19.(Use the round, threaded holes on the yoke.)

5.Use the Height/Y Adjustment T-Screws/Washers (item #3), Pitch Adjustment T-Screws/Washers (item #4) and T-Nuts (item #9) to attach the Pitch Adjustment Yoke and Lens Adapter Ring to the Anamorphic Lens Holder. The Yoke should be as close to the primary lens as possible.

6.Attach the lens to the Lens Adapter Ring by threading it clockwise.

Lens threads into ring

SUCO

F

Figure 3-19. Attaching the Anamorphic Lens to the Lens Adapter Ring

Runco VX-22i Installation/Operation Manual 39