Runco VX-6000D manual Vertical Lens Shift

Controls and Functions

1.VERTICAL LENS SHIFT

Using a 3/16” hex wrench, turn this to move the lens up or down.

2.POWER LED

Lights red to indicate that the projector is in standby; lights blue to indicate normal operation.

3.TEMP LED

Lights red to indicate that the projector has overheated and shut down.

4.INTAKE VENTS

Cool air enters the projector through these vents. To prevent overheating, ensure that these vents are never blocked.

5.LAMP LED

Lights blue to indicate normal lamp operation; off when the lamp has failed or the projector is off.

6.EXHAUST VENTS

Hot air exits the projector through these vents. This air can be quite hot. Ensure that there are no heat-sensitive objects near them and that they are never blocked.

7.RUNCO LOGO / LENS CONTROL INFRARED (IR) RECEIVER

During initial installation, rotate the logo plate one quarter-turn (90 degrees) to uncover the lens control IR receiver. This enables you to use the motorized focus and zoom (image size) controls.

When you have finished adjusting the zoom and focus, you can rotate the logo to match the projector orientation: inverted (ceiling-mounted) or upright. To rotate the logo, grip it at the sides, pull it away from the projector and turn it.

8.LENS

9.JEWELRY RETAINING SCREW

Loosen this screw to remove the front jewelry, should you ever need to replace the lens.

10.CABLE OPENING

Pass cables through this opening.

11.HORIZONTAL LENS SHIFT

Using a 3/16” hex wrench, turn this to move the lens left or right.

12.LAMP COVER

Remove this cover to access the lamp compartment.

13.REAR PANEL ACCESS DOOR

Open this door to access the rear-panel connectors and built-in keypad. To open the door, push on the left side of the lever and rotate it 90 degrees clockwise. Then, pull the lever toward you and down slightly.

1

2

3

6 Runco VX-6000d Owner’s Operating Manual