Runco VX-6000D manual Turning on the Power, Connecting to AC Power

Installation

Projector/DHD Controller: The VX-6000d system includes two (2) AC power cords	Connecting to AC Power
(one each for the projector and DHD Controller).

Plug the female end of one power cord into the AC receptacle on the rear of the

VX-6000d (AC 100V ~ 240V). Then, connect the other end to your AC power source.

Similarly connect the DHD Controller to a nearby AC outlet.

AutoScope Lens Motor: With AutoScope-equipped projectors, a third power cord is provided for the lens motor. Plug the female end of the AC power cord into the AC input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power source.

The input voltage to the AutoScope lens motor must be between

Caution 100 and 120 VAC. Do not connect the AutoScope lens motor to a 200-240 VAC power source!

1.Turn on your source components.

2.Turn on the main power switch at the rear of the DHD Controller.

3.If this is an AutoScope-equipped projector, turn on the main power switch at the rear of the AutoScope lens motor. The lens motor power switch is located next to the AC input (see Figure 3-14).

4.Press the ON button on the remote control -- or the POWER () button on the DHD Controller front panel -- to turn on the system. The vacuum fluorescent display on the DHD Controller front panel briefly displays “Starting Display.”

5.When the projector is ready for use, the fluorescent display indicates the active source, signal format (NTSC or PAL), input resolution and aspect ratio; for example:

		Input
Current Source	Format	Resolution

3.7

Turning on the Power

Component SD NTSC 1080i

Anamorphicvx2k/6k

Aspect Ratio

Runco VX-6000d Owner’s Operating Manual 39